1967 Mercury model 110 question.

[MTboatguy]

I have a '67 model 110 that needs a cylinder block cover gasket and the nylon tell tale fitting on top of the block, it is the little 1/4" elbow fitting on top of the engine that attaches to the rubber tube that runs down to tell tail pipe. The problem is, everything single online catalog I look at is telling me my serial number is not found when I go to look up the part numbers. I can find these items for later model engines, but have not had luck finding them for the '67. So I am wondering how many years were these exact same parts used, I have looked at them for other years and they look the same, so would I be correct in thinking they would be interchangeable on my motor? I even checked here on IBoats, no items listed in their online catalog.

My serial number is #2287545 which falls in the 1967 model year.

Thanks.

 

[Boat Doctor1]

that should be a natl pipe thread?? -therefore use a brass 90 degree elbow from auto parts! likely is a 1/16 or 1/8!! pipe thread!id bet 1/8th! is yours removed or broken off? napa should have that !.

 

[MTboatguy]

Not broken, Just leaking and can't be tightened without breaking it off.

 

[emckelvy]

Here's your parts diagram, you'll want to look at reference numbers 8 & 28 on the diagram:

http://www.marine engine.com/parts/mercury-outboard-parts/110/1865779-thru-2798056/cylinder-block-and-crankcase-assembly

Copy the address to your browser and take out the space between "marine" and "engine" (this site parses links to competitor's websites).

Hope that helps..........ed