1965 Johnson 9.5 HP water pump access problem

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
When the steel of the crankshaft rusts it becomes " iron oxide ".---This means that there is now more material in the spline area.----That is how nature jams things up.-----I use an adapter and slide hammer to remove shafts like that.---Hopefully there is not too much material rusted out of the spline.----And you have to clean that out as the iron oxide is abrasive.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
Check the impeller housing for damage ($95 item). The $125 housing assembly under the impeller probably survived, but the driveshaft seal might leak. Likewise, after banging on it with the shift rod still connected, it would be good to check the upper and lower rod function before reassembly. There is probably some likelihood that the rod bushing/O ring will leak, and that may need attention along with the driveshaft seal.

You can test the seals to see what you have. Once you get the driveshaft out, reinsert it in the l.u. With the gearcase drained, pump in a little bit of pressure with a bike pump or similar (have to devise a way of pump in air -- rubber gasket material and the inflation needle work fine in the drain or vent hole, held in place for the test.) Replace the other plug and immerse the unit in a tub of water. Look for bubbles to locate leaks. Alternatively, you could bring the l.u. to a shop and have them do a pressure and vacuum test.
 
Top