1963, 5.5 Hp Evinrude Issues

44 Echo

Recruit
Thread starter
Joined
Sep 23, 2016
Messages
2
Looking for some help, please. Here is what I know....

Engine will start.

Responds to high rpm carburetor screw.

Sometimes will low idle.

Shifting into gear stalls the engine.

Once engine stops, its hard to pull, feels like engine has excessive compression.

Pulling the plugs does not relieve pressure.

Fuel mix 25:1

Fuel weeping out of carb.

​Plugs wet.

Starts again after sitting a while.

Any suggestions would be extremely appreciated.

Thanks!
 

RCO

Petty Officer 1st Class
Joined
Jun 15, 2016
Messages
350
Fuel leaking out of the carb is obviously an issue, but not why it would be hard to pull over after stalling. What does your LU oil look like? I would be suspicious that the lower unit is rusted up.
 

Wolfs_hell

Cadet
Joined
May 20, 2010
Messages
10
Hello! I'm not an expert, but it looks like you might be getting fuel buildup inthe engine. I had similar problems with my 1954 johnson 5.5. So here is waht i would do.
1: pull both plugs, check if the plugs have carbon buildup. If so, there is a good chance you have not enough spark or too much fuel-or both. The wet plugs can be either reason or both as well.
2: check for spark. With both plugs removed, reconnect the spark plug wire to the plug, then hold the plug 1/4 inch from the engine while pulling the starter. Hold ot by the rubber boot or youll get a shock. I Cleaned the paint off a bolt for this. The plug should spark across the plug gap then to block. Remember to check both plugs/wires. If the spark dosnt jump the 1/4", check and clean/replace points and try again. If still not enough spark, repalce the condesers then the coils if necessary.
3: if your carb is weeping, you might have it too rich, and its putting too much fuel into the cylinders. I had this happen with one of my outboards, it would run at high speed and die at idle due to flooding. The incomplet fuel burn may also be why the cylinders dont want to move even with the plugs pulled. Set the needles for one to one and a half turns open, then try to start it. Turn down by1/8 turn and try again, and repeat. I wouldnt try to run it below 1/4 open though.

I would check for spark first, and if you have good spark move to fuel settings. If no good spark, youll have to take care of that anyway. Also, if its been a while i would do a carb clean and rebuild. If you do it yourself, and shop around for parts, you can get coils, condensers, points, and a carb kit for under $100. Also, there are articals and youtube videos on all this to help.
 
Last edited:

racerone

Honorary Supreme Mariner
Joined
Dec 28, 2013
Messages
40,028
Hard to pull over after it stops ?----Have you checked the water pump?-----Checked for overheating ?
 

44 Echo

Recruit
Thread starter
Joined
Sep 23, 2016
Messages
2
Thanks, fellas! As it turned out, I kept "drilling down", by taking the carburetor apart. Fuel problems most likely caused by a dissentegrating float, made out of cork. Bits and pieces all in the bowl, and throughout the fuel system. I pulled the lower unit again, the new pump I just put in dissentegrated by aluminum oxide that was in the water jacket. Pulled the new thermomstat and found it all packed up. Pulled the head and found the source. Broke two (2)bolts off pulling the head and cracked the block. Water jackets packed with aluminum oxide, power head is now toast. Most likely will part out what's left.
 
Top