1961 evinrude lark 3 issues running

HuronBoater

Recruit
Thread starter
Joined
Jun 22, 2016
Messages
5
I recently bought a 1978 fiberglass glastron with a 40hp evinrude lark 3. The guy I bought it from had it rebuilt 2 summers ago and he ran it last year but it sat out all winter last winter. It starts up but it does not like to sit at the starting throttle otherwise it sounds like it has a bad miss then putters to a stop. It puzzles me because I ran it wide open and it ran fine. Any ideas?
 

jimmbo

Supreme Mariner
Joined
May 24, 2004
Messages
14,699
Welcome to iboats.
You ran it wide open? I assume you were on the water? When exactly did you buy it? Was it winterized as in, putting a fuel stabilizer in the gas? Fogging the engine with storage oil?
 

HuronBoater

Recruit
Thread starter
Joined
Jun 22, 2016
Messages
5
I bought it last wednesday, and I don't believe so it sat all winter without a cover or anything.
 

lindy46

Captain
Joined
Nov 27, 2008
Messages
3,886
Probably needs a carb cleaning/rebuild. I'd pay special attention to the slow speed circuit. Remove the welch plug on top of the carb and clean out all the passages underneath. If it was a new to me motor, I'd begin with a compression and spark check, but it sounds like the motor runs pretty good at high speed. Good to run those checks anyway.
 

deeldavid

Cadet
Joined
Dec 16, 2014
Messages
6
Guys can anybody help me troubleshoot a 75hp evinrude starflite 1960 ? I got it started but after a few minutes the exhaust water gets really hot and steamy, is this a head problem , normal or something else ? I'am new on forums and old boat motors !! HELP
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
would like to follow the '61 lark thread. Can you start one of your own on the Starflite? This forum (J&E).
 

HuronBoater

Recruit
Thread starter
Joined
Jun 22, 2016
Messages
5
I believe I may have found my issue. One of my spark plug wires was rubbed through causing my plug to incorrectly fire before It could get to the points. I have yet to check the points that's a project for today,thoufg
 

HuronBoater

Recruit
Thread starter
Joined
Jun 22, 2016
Messages
5
I believe I may have found my issue. One of my spark plug wires was rubbed through causing my plug to incorrectly fire before It could get to the points. I have yet to check the points that's a project for today thou gh
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
If a plug wire, that's some serious abrasion (pretty stout). If replacing a plug wire, use 7mm solid core (can usually get it at NAPA). If it's a smaller wire under the flywheel, coil to points, you can probably mend it -- maybe a touch of super glue to cover the wire. Typically, it can happen if wiring isn't tucked in and contacts the flywheel.
 

HuronBoater

Recruit
Thread starter
Joined
Jun 22, 2016
Messages
5
It's rubbed off due to part of my throttle coming from my plug. Could I just tape that or would I have to get a new one?
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
?? not sure what you are describing, but if it's a plug wire I would replace it.
 
Top