1960 Super Sea Horse 40 O ring

[steve62]

When I took the lower unit out today I noticed that there wasn't an O-ring at the top end of the drive shaft where it engages the lower part of the engine. Where can I get this O-ring from? Is it part of the lower unit gasket set? Any help is appreciated.

Regards,
Steve G.

 

[F_R]

Re: 1960 Super Sea Horse 40 O ring

If it isn't part of the seal kit, it should be. Otherwise, it is a standard o-ring available from places like Ace Hardware, if you know the size. I'm fairly sure it is 3/32" thick.