1958 Johnson RDE-19 35hp Overheating

jonnyboy32

Recruit
Thread starter
Joined
Oct 7, 2011
Messages
3
I have a 1958 35hp RDE-19 Johnson motor and I am hoping you can help me. We do not have a boat mechanic closer than over 2 hours so I have been forced to troubleshoot my motor by myself. It has a new impeller and is pumping water but overheats quickly anyway. It was built before thermostats so I know that?s not the problem. Do you have any idea what it might be or what I am missing? Here is a link to some of the blowup diagrams and parts lists I have found. Thank you!!!!

http://www.marineengine.com/parts/johnson-evinrude-parts.php?year=1958&hp=35&model=RDE-19
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Not enough information to make a real diagnosis. You say it is pumping water but still overheating. The cooling system on that motor is uber simple and it would be hard for water to flow through it and still get hot. Where are you running it? How do you know it is hot--what area of the motor is hot? Maybe not enough water is flowing. Maybe you are running it in a mop bucket. Maybe the pump housing is worn or sucking air. Does it pump at slow idle? Or maybe there is localized obstruction in the cooling system.
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
^^intake obstruction? overheating before impeller change? (i.e., installation issue? water tube missed grommet?)
 

jonnyboy32

Recruit
Thread starter
Joined
Oct 7, 2011
Messages
3
Found the problem. I took the head apart to replace the head gasket. When I cleaned out the top of the head and all of the channels, large amounts of moss and debris came out. It now blows through cleanly. I also checked the water tube and it is blowing clear to the head too. After sanding down everything and making it smooth I put the new head gasket in. It runs super cool now, but it is leaking water from the bottom of the head gasket. I am not sure how to fix that, its my next project. Thank you for your help!
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
need to resurface the head. Can probably reuse your new gasket, but remove the head and sand the mating surface using a flat surface and 400/600 grit wet/dry sandpaper. Move the head around in a figure 8 pattern. In addition, need to torque the head to specs using circular pattern starting in the middle.
 

HighTrim

Supreme Mariner
Joined
Jun 21, 2007
Messages
10,486
Glad you got it. Did not hear back from you in email, so figured you licked it.

Head torque bolt is very important. So is the pattern in which you tighten them.

Start in the center, and spiral outwards in a circular pattern. Do it in 3 passes. First pass, 120 inch/lbs, second pass 180 inch/lbs, final pass 240 inch/lbs.
 
Top