1958 10hp no spark

Rymasta

Recruit
Thread starter
Joined
Dec 18, 2015
Messages
1
Hey everyone,

This is my first time working on any outboard and sorry if I forget any information. I recently started working on a 1958 evinrude and have done the single line conversion for the fuel line. I went to test to find I wasn't getting any spark using a spark plug tester. I've tested the coils and spark plug wire which have the appropriate readings on my multimeter, however when testing the breaker points I thought I was having some continuity issues so I ordered new ones and reset the gap to .020 But still no spark. Any advice is appreciated.
Thanks!
 

oldboat1

Fleet Admiral
Joined
Apr 3, 2002
Messages
9,612
on wires: spring clips at plugs (inside boots) -- spike needs to contact wire core. at coils, spike needs to be in solid contact with wire core. No breaks in wires. (need 7mm solid core).
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Even new points need to be cleaned. They develop a non-conductive coating during long storage.
 

64osby

Admiral
Joined
Jul 28, 2009
Messages
6,826
Did you replace the condensers at the same time you replaced the points?
 

Johnson110

Chief Petty Officer
Joined
Dec 31, 2003
Messages
640
Running 120 cloth grit across points then clean up with some acetone on card would that be right way yo clean them?
 

HighTrim

Supreme Mariner
Joined
Jun 21, 2007
Messages
10,486
Many ways to do it. If the points are out, I like to hit them on my wire wheel on the bench grinder quick. That gives them a quick, high polish.

There are points files that you can buy that work well. Or, wrap paper around a hacksaw blade and run that through.

Then, after polishing, blow off with compressed air. If you used a sand paper, you don't want any of those non conductive particles left on the points face or they will be useless. Then, after blowing off, as stated, dip a business card, or paper stock in acetone, and run that through to clean. You will see black streaks left on the paper that if left on the points would have limited spark. I then blow off again with the compressed air, and you are all done!
 
Top