1956 Johnson CD-13 (5.5 hp) Tiller question

Jeffbo1

Recruit
Thread starter
Joined
May 20, 2016
Messages
2
I recently acquired a 1956 CD-13 and right away I noticed that the tiller gear was not contacting the joint gear unless I pushed the grip toward the engine to engage the gears...obviously something is amiss especially since it wasn't turning smoothly either, and having taken it apart I am not sure if someone had taken it apart and not reassembled it correctly? Does anyone have a diagram or can anyone describe the order by which the parts go back in so that it will function properly? Ive tried various ways and am at my wits end over a simple device....many thanks
 

F_R

Honorary Supreme Mariner
Joined
Jul 7, 2006
Messages
28,226
Well, you can dink around with it and try shimming. Remove the gear/shaft assy from the tiller and check the washer that goes against the gear, and maybe add a bit of thickness to it. However, 1956 was a year of mid-year change on those parts. They went from stamped brass gears to case bronze ball gears--way better. Do yourself a favor and replace them with the new style parts. You will need a part number 376691 gear & shaft assy, long, for the tiller and a 376689 gear and shaft assy, short, for the steering bracket.

Post a free want ad on the Webvertize forum at the Antique Outboard Club's website, www.aomci.org Somebody there will have the parts.
 

Jeffbo1

Recruit
Thread starter
Joined
May 20, 2016
Messages
2
Thank you for the info, sounds like Im possible missing that washer...that would solve the problem for sure....but i will certainly look into new parts just to make it operate more smoothly if anything....thanks again!
 
Top