04 seadoo gtx sc mixing water and oil

[attowing@yahoo.com]

i just bought the ski and some one told me to rinse the motor i had to put the water hose on top left of the impeler. i did that and it loaded the motor with water and it mixed with the oil.is that the rinse plug?? the water hose screw in it.and if that is what could me wrong.please help this thing is kicking my a**

 

[Jeff Walkowiak]

Re: 04 seadoo gtx sc mixing water and oil

you need to get the water out fast,, change the oil several times and add some auto trans fluid to the first oil change as it will mix with the water,, what you did was run the hose with the engine off,, you can not have the hose on if the engine is turned off, the water will feed back in to the engine..
attach a male quick connect to the flush port, add a female quick connect to your hose end and use one with a on and off valve built in .
when you conect the hose have the valve turned off,, then start the engine and turn the valve on, after a couple minutes turn off the valve and remove the hose, then hit the throttle a couple times to blow out water from the mufflers, then turn off the engine.

 

[attowing@yahoo.com]

Re: 04 seadoo gtx sc mixing water and oil

ok i was doing that and while i was cranking the motor water was shooting out..alot and it stoped cranking and i have no ignition it beeps one long beep and doesnt show nothing on the cluster.and it wont crank.what you think??

 

[Jeff Walkowiak]

Re: 04 seadoo gtx sc mixing water and oil

answered you on your other post,,also if all else fails and you need to crank out the cylinders jump a hot positive wire directly to the starter lead