Search results

  1. Oberlieutenant

    Overhauled '63 Johnson JW-18R (w/pics)

    1963 Johnson JW-18R. Went from this: To this:
  2. Oberlieutenant

    Re-installation of Johnson impeller shaft?

    Anyone know the proper procedure for re-installing the impeller shaft on a Johnson 3hp? I replaced the impeller and now can't get the housing to re-seat into the lower unit properly - there's about 1/2" to go.
  3. Oberlieutenant

    Wooo Hoooo!!! It lives!!!!!1

    I got my little 3 hp Johnson running today! It ran a little smoky, but I *think* I mixed the fuel/oil a little too rich. No signs of overheating, but I am going to replace the impeller anyway. Thanks to all who offered advice and assistance! And a big thumbs up to Tom at...
  4. Oberlieutenant

    Busted cylinder head bolt - '63 Johnson JW-18R

    Okay, it sucked, but I got it out. I had to use MAPP gas and Vise-Grips to extract it. Is there a chance I damaged the integrity of the engine by using such intense heat on the cylinder walls?
  5. Oberlieutenant

    Another 1963 Johnson JW-18R question

    Help - I need plug wires! Can anyone tell me where to pick up a set of model-specific replacement wires? Edit: if not, does anyone know what will work instead?
  6. Oberlieutenant

    3hp Johnson won't run

    Okay, here's what I've done: Drained gas Cleaned carb with solvent and air Changed plugs The motor sat for a few years, so there was a significant amount of varnish in the carb, but I'm certain I got it all. If I shot a little ether in to the silencer, it would fire and then die. One of...
  7. Oberlieutenant

    Need parts for a '63 Johnson JW-18R

    Anyone here know of a good resource for parts for these motors? I need some of the cosmetic pieces as well as some other misc. things. Thanks!
Top