The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I have a 24ft deck boat 150 ox66 planes out instantly just stays flat and goes i guess because how long my boat is, now im running 5400 rpm and doing low 30s so would it be worth going up 4 on pitch to gain speed loose rpm but i think i will still plane well and maybe save mpg
I bought a boat with no lower part of the outdrive but i found a whole outdrive with different gear ratio if i leave my upper that on my boat and just put the bottom part of the foot will my gear ratio stay the same
my block was cracked and I found a good used 5.7 same year model as what was in my boat a 97 , the only difference is it is set up for alpha and I have a bravo, so what all do I need off the old engine ?
I have a new e tec 115hp with single binnacle control my problem is i use about 70 percent of throttle cam from idle to full throttle, i know on older controls you just moved throttle cable to a different cam hole in the controls, but mine doesnt have that, it does have two nuts on top of...
if anyone has the service manual can you post a copy of the page it seems like the link and sync is
good.I just need to set timing..thanks......its the 2 stroke 115
Im might buy a 2004 150 evinrude. its been winterized and we did a cold compression test , its been setting for 2.5 months, the numbers came all out to 100 all 6 cylinders do you think they would get back to 120 range once i start useing it again
I want to clean my cyl and rings in a 99 optimax 200hp, runs good i just got it and it still hade the same plugs from 11 years ago and ran well!!!! I changed the plugs and noticed some carbon so who has the best way to clean
i just bought a 200hp opotimax (1999) we took it to the water and it rode perfect then for fun i did a compression test all are 93psi-98psi SO I KNOW THIS ISNT VERY GOOD BUT IT RODE SO WELL, HOW BAD IS THIS
my service man. says to adj. THROTTLE CAM LINK to 53mm but doesnt tell from what point.(end to end)or(center hole to center hole) and how do i tell if its a (e115a)(c115tr)or all outher it says 115tlrb bellow 6e5 L 1004362 FAMILY 3YMXM1.731CA
what is the little 1/4 hose running out the top mid section and it has a small plug in it and how do i change my lower unit fluid i see the fill but no vent im thinking that hose might be the vent thanks ahead of time
i started both eng today and let them run 2 min and the oil on the small lines on top of res never started pumping is this a problem or do they run ritch until they warm up i havent started in about 3 weeks and is there a starting procedure