The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I have a 2000 4 stroke 50 Hp Yamaha. T50TLRY High thrust on a 24 ft. pontoon. The trim inicator switch works - if I move it by hand. However, the trim switch isn't engaged at all until the motor is 90% in the down positon. When all the way down, the most I can adjust the switch is to move the...
Can anyone guide me to a Hewitt cantaleiver lift diagram and or technical specs that shows the cable routing? The Hewittt Mfg site is useless.
Thank you
I purchased a used stainless steel prop for my 1994 Merc alpha one. It fits on the splines just fine. However, it seems like it goes too deep into the gear housing and I can hear metal on metal rubbing when I spin it by hand. This is without even tighting the hub. The old alum. doesn't do...
I just installed a new on-board dual bank battery charger to charge my two 12 v deep cycle batteries. the batteries are wired in series to power my 24V electric trolling motor.
The boat is moored in all summer and I was planning on leaving the charger pluged in to charge and maintain the...
I having a strange issue when operating at WOT - or actually anywhere over about 4000 RPM. The boat starts and runs excellent. Out of the hole its fine. after a few seconds of running over 4000 RPM, it feels like someone is suddenly pulling back on the throttle and then pushing it forward...
I have a 1987 Mercruiser 4 Cyl 165 HP I/O I need to replace the starter. Can anybody offer advice on how to remove the inside 9/16 nut? I can loosen the outside nut with no problems. I can get a wrench on the inside nut but I don't have any room to move the wrench to loosen it. Any help...
