Search results

  1. C

    lower unit/ impeller gasket seals

    Thanks. I’ve done an impeller but noting more on a mercury. Will drop it today.
  2. C

    lower unit/ impeller gasket seals

    I bought a lower unit seal kit and an impeller kit. Will they come with everything?
  3. C

    lower unit/ impeller gasket seals

    Okay good deal. Do I have to worry about the shift shaft coming out?
  4. C

    lower unit/ impeller gasket seals

    Will do. How is that one changed?
  5. C

    lower unit/ impeller gasket seals

    Hey had a question about impeller seals. I noticed a little water in my oil. I have a 1984 mercury 150 black max. Im wanting to change the impeller and gaskets. I noticed o rings in the kit. How does the base come off under the rubber impeller? Are there seals and o rings under that? Also the...
  6. C

    9 amp to 16 amp stator overcharging

    6 wire like this one?
  7. C

    9 amp to 16 amp stator overcharging

  8. C

    9 amp to 16 amp stator overcharging

    Gotcha. May try and run it like it is and keep an eye on it
  9. C

    9 amp to 16 amp stator overcharging

    20 amp should work? 16 amps without regulator didn’t damage battery or anything by overcharging?
  10. C

    9 amp to 16 amp stator overcharging

    This what I need?
  11. C

    9 amp to 16 amp stator overcharging

  12. C

    9 amp to 16 amp stator overcharging

    is this a rectifier/regulator or do I still need my small square rectifier?
  13. C

    9 amp to 16 amp stator overcharging

    Thanks. I tried a used one off eBay similar to this one but it didn’t have the 2nd red wire
  14. C

    9 amp to 16 amp stator overcharging

    Sorry mercury black max 150. 1984
  15. C

    Black max temperature sensors

    Yeah both sensors are held in with a bracket with 2 bolts. The starboard pushes in with a rubber grommet and has a coil spring on it. The port side is 1/8 pipe thread with the same kind of bracket. I’ll trace down that wire and see if it’s open. I’d say it is. Thanks
  16. C

    Black max temperature sensors

    The starboard side sensor went to a junction block with a tan wire that runs through the harness connector But I couldn’t find anything for the port sensor. I see a pinkish bullet connector on the starboard side of the harness that could have been ran at one time but wasn’
  17. C

    9 amp to 16 amp stator overcharging

    Finally getting everything worked out on this motor. Stator was bad and thought it was the 16 amp stator but turns out it was a 9 amp. My engine only has the small square rectifier. It is overcharging the battery. Maxed out the gauge at 16 volts. I don’t want to burn anything up. Can I add a...
  18. C

    Black max temperature sensors

    The one on the starboard side is a tan wire. I traced it to the controls for an alarm. Is there a wire in the factory harness for the port side for a gauge?
  19. C

    Black max temperature sensors

  20. C

    Black max temperature sensors

Top