Search results

  1. D

    Wiring help

    Thank you sir! The amp/inverter are only about 2.5ft from the buss bar the starter is 12ft and the m-acr is 4ft i will run the numbers this weekend and make sure all jives and will also rest out the calibrated touch method! Thanks again!!
  2. D

    Wiring help

    Correct there is no AC panel and the “extension cord” is a flush mount waterproof housing 110v type outlet so i can plug in on the outside of the compartment vs directly into the inverter. Yes the factory dc fuse panel in the console. I completely overlooked the fuses for the M-ACR and...
  3. D

    Wiring help

    Heres the main fuses/breaker. I will draw up the console fuse panel if needed also
  4. D

    Wiring help

    Yes it is a small jumper basically from the inverter chassis to the ground its how the manual instructed.
  5. D

    Wiring help

    All the house items except the inverter and amp are ran to the console where theres a fuse block that has everything routed off of. The amp has an inline fuse as does the inverter and there is a 100amp breaker between the switch and the house buss bar. I can annotate when i get home on the...
  6. D

    Wiring help

    I forgot to add the 100amp inline breaker between switch and battery buss bar on the house side
  7. D

    Wiring help

    Thank you wire should be fine its probably a size larger than needed across the board
  8. D

    Wiring help

    Heres my schematic 😂 dont judge my artistic skills. The 3.0 is a inboard/sterndrive motor. 4cyl.
  9. D

    Sn lookup help

    Thank you thats very informative. Yes i could look it up most times and it would say sn 0000-0b123 but would be true for multiples so the confusion set in.
  10. D

    Sn lookup help

    Good to know thank you
  11. D

    Sn lookup help

    Thank you i know it normally goes as a 0 first the valve cover didnt have it so was just curious. Thank you
  12. D

    Sn lookup help

    I have an older Mercruiser that i believed was a 3.0 but am second guessing now that i may be a 2.5. I cant find a good way to verify. The Valve cover has A654482 on it. I will try to locate sn on the block to verify thats correct. Thanks for any help.
  13. D

    Wiring help

    Curious before I clean everything up and finish routing wires if I am doing something wrong and looking for input. 30' pontoon with 3.0 Mercruiser 3 batteries 1 starting, 2 House Mini add a battery I have two house batteries tied together running to my switch then to a buss bar and the start...
Top