Search results

  1. R

    Replacing Ball Drive Seal on OMC Stern Drive:

    How difficult is it to replace the outer seal around the ball gear drive shaft on a OMC 800 out drive? Boat is a 1985 Cobalt 5.7 litre. I have a drip leak coming into the bilge from that area. Rich
  2. R

    Rubber Carpet Backing-How to Remove?

    I have just pulled the carpet from my boat. Beneth the carpet it left pieces of rubber and adhesive. I tried paint thinner on the entire fiberglass coverd floor to no avail. Is there a solvent for this purpose. Thanks! Rich
  3. R

    Salt Water on Bendix:

    I recently took my here-to-fore fresh water 85 Cobalt I/O to the Gulf. After 2 trips and over a 6 month pewriod the bendix refused to engage the fly wheel. I pulled the starter and the armature shaft had corroded. How would salt water have gotten to the starter drive? After rebuild, have I...
  4. R

    Resealing Lower Unit:

    I have a 1985 OMC 800 outdrive on my :confused: I/O Cobalt that takes on water in the lower unit. I bought a replacement seal kit from Doug Russell and wonder what I can expect a reputable dealer to charge to install the seals? Also, would it be unreasonable to have the prop seal replaced...
  5. R

    Eratic Fuel Guage:

    My fuel guage reads correctly when the tank is above 3/4 but below 3/4 it become eratic and bounces from 3/4 to empty. Is this most likely the sending unit? The boat is 20 years old. Thanks! Rich
  6. R

    OMC Lower Unit Seal:

    What is the best way to remove and install propeller shaft seals on OMC 800 inboard/outboard drive? I have an 85 Cobalt. Rich
Top