Search results

  1. Promag

    Where’s the gas gauge sending unit ?

    There is some sort of access plate starboard and port side . I must cut carpet and a couple inches of foam just to see what’s underneath the access plate .I figure it must e for the sending unit ,but I’ve figured wrong before . Hate to star tearing into something without knowing what is where .
  2. Promag

    Where’s the gas gauge sending unit ?

    Correct. But the top of the tank where the sending unit is , is way under the floor . I have access to all the fuel lines , but not the sending unit. I can not put more than a few gallons of gas in the onboard tank without leakage . Some tell me I have to remove the floor to get to the top of...
  3. Promag

    Where’s the gas gauge sending unit ?

    I can’t access the top of the tank . I have the vent , filler and pickup . The sending unit is under the darn floor with no visible access .
  4. Promag

    Where’s the gas gauge sending unit ?

    The sending unit is way under the floor . There is a black plastic plate on the floor . Upon inspection there is carpet,glued down . There is a hole in the floor but cutting the carpet , the hole is filled with foam . I hate using a outboard tank but until I figure it out ,it’s 6 gallons per...
  5. Promag

    85 horse dropped number 3 cylinder.

    Refinish it as in Grand it flat or just stone it ?
  6. Promag

    Where’s the gas gauge sending unit ?

    Would there be a access under the carpet ? There are two plastic plates on the floor in back
  7. Promag

    Where’s the gas gauge sending unit ?

    Here’s the unit .
  8. Promag

    Where’s the gas gauge sending unit ?

    Considered a extra gallon tank . I did use a hose and measure the wetness for some measure of volume.
  9. Promag

    Where’s the gas gauge sending unit ?

    Here’s the boat
  10. Promag

    Where’s the gas gauge sending unit ?

    I have been looking for 3 weeks . The tank with the filler ,vent and pickup are all accessible. The vent hose was cracked and leaking ,fixed that . There has to be a access without cutting into the floor . No room to look under the floor ,what looks like access is just a plastic plate over...
  11. Promag

    85 horse dropped number 3 cylinder.

    I know head gaskets are common I’ve had this one changed . Good advice , nothing to loose .
  12. Promag

    85 horse dropped number 3 cylinder.

    I did not investigate personally but I DID have a guy use a bore scope . The bottom cylinder is very tight . When I can I will pull the head ,I do have a head gasket . A hone ,piston and rings ain’t that hard . I did buy another boat. But still love my Bayliner and Force 85 . 25 years...
  13. Promag

    85 horse dropped number 3 cylinder.

    I have a 89 Force 85 3 cylinder. Seems the lower cylinder has gone bad . New power head or tear into it and try to fix it ? Any advice ?
  14. Promag

    Where’s the gas gauge sending unit ?

    I have a 93 pro mag 16.1 . Gas gauge doesn‘t work . Gauge is good , no signal from the sending unit . How do I access the sending unit ? Is there a access hole someplace? thanks ….
Top