Search results

  1. M

    Mercruiser 2011 3.0 TKS issue

    I forgot to mention that I noticed a oily residue when I pulled the flame arrester off. See picture attached with the area highlighted.
  2. M

    Mercruiser 2011 3.0 TKS issue

    Thanks again for the help. I've never worked a carb before but have done lots of mechanical work in the past, for example rebuild my Honda engine many years ago. If I find gas dripping I assume I should pull the top off the carb and check the float. What do I need to look for / correct. I've...
  3. M

    Mercruiser 2011 3.0 TKS issue

    Will check for dripping gas, forgot to do that yesterday. Thinking of doing a carb rebuild anyway ... thoughts?
  4. M

    Mercruiser 2011 3.0 TKS issue

    Sorry, it was initially posted in the wrong forum and didn't know how to move it so re-posted it. It will not happen again. Thanks for the feedback
  5. M

    Mercruiser 2011 3.0 TKS issue

    Just realized I posted this in the wrong forum. Re-posted in mercruiser forum. Sorry for the mistake
  6. M

    Mercruiser 2011 3.0 TKS issue

    Hello, I've been trying to resolve a warm start problem with my 2011 3.0 TKS. Here is the initial problem: hard start when run until warm (30 min) and then off for a while - hard to start but always starts. Last two times out trying to troubleshoot and now it hardly runs at low RPM, starts okay...
  7. M

    Mercruiser 2011 3.0 TKS issue

    Hello, I've been trying to resolve a warm start problem with my 2011 3.0 TKS. Here is the initial problem: hard start when run until warm (30 min) and then off for a while - hard to start but always starts. Last two times out trying to troubleshoot and now it hardly runs at low RPM, starts okay...
  8. M

    Alpha 1, gen II trim gauge ok out of water but running in the not

    Thanks for the suggestion, I was also suspecting that. It was some time ago that I first checked and will need to pull it and check again.
  9. M

    Alpha 1, gen II trim gauge ok out of water but running in the not

    Hello, I've been trying to solve the problem with my sterndrive trim indicator gauge. I know how to adjust and when I do it looks good sitting the trailer, key on, not running. When I put it the water and running the indicator is is showing way down (starts way down at the bottom of the gauge...
Top