Search results

  1. R

    Upper Alpha one Gen 2 Replacement

    Alignment and some persuasion and it finally went in there. Thanks for all the help y’all!
  2. R

    Upper Alpha one Gen 2 Replacement

    Thanks for that information. I have the alignment tool and aligned it yesterday when I was trying to stab the upper yesterday. I will re do it today.
  3. R

    Upper Alpha one Gen 2 Replacement

    I noticed the same. Knuckle definitely looks beefier.
  4. R

    Upper Alpha one Gen 2 Replacement

    Old unit is- 00663273 New unit is- 1A292940 Old is without the top.
  5. R

    Upper Alpha one Gen 2 Replacement

    Visually they definitely look different. I haven’t actually measured so I will do that tomorrow. The “new” one visually looks bigger. It doesn’t taper off as slow as my old one. Good information on the stamped letters tho. Thank you for that.
  6. R

    Upper Alpha one Gen 2 Replacement

    The length seems to be the same. It is actually the diameter of it. My original is labeled C and the “new” one is labeled D. I tried to install it and it would not go in. Splines were lined up because I verified by spinning the motor by hand and the splines turned with it.
  7. R

    Upper Alpha one Gen 2 Replacement

    Recently destroyed my upper Alpha 1 Gen 2 1.81ratio on my 93 Manta Ray. I believe it was the original apparently had some slack in it and jumped a tooth or something. Anyways it’s gone. So I ordered a used one off eBay. I know should have went SEI but I didn’t so I’m here now. The upper I...
Top