Search results

  1. J

    plans for outboard motor stand...anyone?

    Hi, I would like to build a wooden stand - with wheels (for ease of moving)for my 40 hp outboard motor. Does anyone have any good ideas / suggestions for this? :p
  2. J

    plans for outboard motor stand...anyone?

    Hi, I would like to build a wooden stand - with wheels (for ease of moving)for my 40 hp outboard motor. Does anyone have any good ideas / suggestions for this? :p
  3. J

    coil insulation cracked 69 evinr'd 40 hp

    I took off my flywheel to check points, condensers, and coils. The coils insulation was cracked and one had small pieces of the insulation missing. Should i replace them? :confused:
  4. J

    1969 evinrude 40 hp flywheel pulling

    Hi, I'm trying to pull the fly wheel to replace points and condenser, but i'm having a hard time getting it off. I have followed my manual as closely as possible but i thought i would ask if i was doing it right before i break something. I have posted a couple of photos.<br /><br /> web page...
  5. J

    Please help identify this piece...

    While looking closer at my 40 hp Evinrude I found a small steel piece laying in the bottom of the engine housing...it looks to me like it may be carburator linkage??? Can anyone identify this piece. Just follow this link to a photo>>>>> :eek: <br /><br /> photo web page (click here)
  6. J

    gearcase still oozing fluid out hole

    Well I have had this gearcase off and back on 4 times now trying to solve this fluid leakage from t6he gearcase. I have replaced all of the seals (some twice)I have a new impellor, impellor housing and seal, driveshaft seal(under impellor), new upper pinion bearing, new screws for prop shaft...
  7. J

    gearcase still oozing fluid,,,

    I removed my gearcase and replaced all the seals<br />I could see in my parts diagram. I pressure tested it and it held air. I reinstalled the gearcase and ran it in a barrel of water. I could begin to see the grayish blobs floating on the surface of the water. I shut her down and sure enough...
  8. J

    1969 40HP Evin lower drive oozing fluid

    Hi, I have a problem with what looks like gear oil mixed with water oozing from a small hole on the gear case. I removed the gear case and and replaced the drive shaft seal (just below the impellor)and also I replaced the impellor, impellor housing with new seal. I ran the motor again and I...
Top