Search results

  1. C

    Alarm Sounds when batteries switched on and no key in ignition

    Thanks to all the suggestions Had to trace the siren wires back pretty much undo clamps on massiveblock wires behind the dash. Was looped into the fuse panel with an extra fuse inline. Then trace wires back to the rear of boat. Which was connected to float switch Cut wires there siren...
  2. C

    Alarm Sounds when batteries switched on and no key in ignition

    Thanks to all the advice received helped a lot to sorting out the issue
  3. C

    Alarm Sounds when batteries switched on and no key in ignition

    Found the issue Had checks done by electrician and found the Rule float switch was the issue Replaced and all good
  4. C

    Alarm Sounds when batteries switched on and no key in ignition

    Yep and I had gave the leg a coat of paint and just read the manual says don't do that
  5. C

    Alarm Sounds when batteries switched on and no key in ignition

    I will look but wouldn't the harness only connect one way. There would be no reason to alter the wire positions in the Junction connector There were no alarms after full service but then had the leg removed and sent away for repair as wasn't selecting gear properly After reinstall leg now have...
  6. C

    Alarm Sounds when batteries switched on and no key in ignition

    No we permanently disconnect the gear oil sensor to eliminate disable that alarm And the alarm goes off regardless of the gear oil sensor The gear oil sensor onl activates if the ignition is ON This alarm activates with no key in ignition at all And only the battery switch in pm position
  7. C

    Alarm Sounds when batteries switched on and no key in ignition

    We have a 2012 Larson Cabrio 777 with a 5.0 mercruiser and bravo 3 leg I Have just had the motor and leg serviced during winter. was a major service including manifolds and risers. And the leg was sent to a specialist for recon. after all the work has been completed. Now i have a constant...
Top