Search results

  1. infoanalysis

    Ring seal can seal the deal -- bf100 '85 cooling

    The gasket, when I removed earlier was metal but had a plastic coating on it. I was wondering does that have to reseat or reseal.
  2. infoanalysis

    Ring seal can seal the deal -- bf100 '85 cooling

    I have a Circa 1980s BF100 long shaft. After fixing the water pump by buying the seal ring that allows water to move up the water tube, I was able to finally see the water pee out the side. But I noticed that water spitting out of the split case of the inlet manifold toward the rear shooting out...
  3. infoanalysis

    Ring seal can seal the deal -- bf100 '85 cooling

    No I think it is okay now. The seal did work and the pee hole is working. But now I notice the inlet manifold leaks water at the gasket seam until it heated up and stopped. IS this okay?
  4. infoanalysis

    Compression test low on BF100 honda mid 80s

    I spoke to a honda OB mechanic he said you would never get it started at only 60 psi. Yet it starts up ok-- not great, but does send alot of spent oil into the water tank as if it were a 2 stroke. I also have an issue with the impellor which I think I solved because of the lower ring seal not...
  5. infoanalysis

    Compression test low on BF100 honda mid 80s

  6. infoanalysis

    Compression test low on BF100 honda mid 80s

    your right
  7. infoanalysis

    Ring seal can seal the deal -- bf100 '85 cooling

    I bought a bf100 circa 85 Honda 10 HP long shaft that did not pee water. When I went to change the impellor I was surprised to find it intact. So I pieced it together ( one of the 4 thread inserts that anchor down the imp housing required a longer bolt -- must have stripped the end of that...
  8. infoanalysis

    Compression test low on BF100 honda mid 80s

    Thanks I'l do my best but sometimes its nice just to give a direct answer to a simple question.
  9. infoanalysis

    Compression test low on BF100 honda mid 80s

    Thanks, that makes sense now that you put it that way. "He who forgets to change his impellor may find himself a stranded fella"
  10. infoanalysis

    Compression test low on BF100 honda mid 80s

    thank you
  11. infoanalysis

    Compression test low on BF100 honda mid 80s

    Thanks, yes that makes sense that the rings might be stuck.
  12. infoanalysis

    Compression test low on BF100 honda mid 80s

    Yes the local outboard shop just told me that Thanks, although it does not make sense since I always thought the throttle dealt with carb not the valves and therefore it wouldn't seem likely that it would effect compression.
  13. infoanalysis

    Older Honda BF100 fuel hose connector interchangeable with OMC?

    why even bother answering that was useless information
  14. infoanalysis

    Compression test low on BF100 honda mid 80s

    I did a compression test on a Honda bf100 which states in service manual that the psi should be over 150 but when I conducted the test I only get about 60psi :(, but consistent between both cylinders :) . Even after spraying oil in each cylinder, as it may have been standing for some time, it...
  15. infoanalysis

    Older Honda BF100 fuel hose connector interchangeable with OMC?

    I just bought a honda BF100 circa 1980s with no fuel tank or hoses.( started up when I sprayed fuel into carb) I see that the female fitting for the engine side 17650 921 003ZB looks very very similar to the Johnson Evinrude old barb style, however the price differential is 5 xs more for the...
Top