Search results

  1. 1

    GLSTA 115 Low rpm idle

    Actually, they were all set to 5.75 and port side did not respond at all, but Starboard did somewhat to my adjustments. Kind of strange now that I think about it. Now they are all around 2.75 and 3 roughly
  2. 1

    GLSTA 115 Low rpm idle

    Think I got it figured out, will need to put in water and run boat for a while. Spark was good on all 4 cylinders. What I did, was I closed the carb needle all the way and just waited to see what happens, after approximate 1 minute engine started to stall, so I opened it 2.5 turns, and started...
  3. 1

    GLSTA 115 Low rpm idle

    It usually stays down there, after running it for a while it will idle smoother, but still wont hold an idle
  4. 1

    GLSTA 115 Low rpm idle

    Will check later on and let you know results
  5. 1

    GLSTA 115 Low rpm idle

    Have not contacted seller yet as I don't know what to tell them because don't know what's going on. Original engine went underwater. Carb bowl not warped, and High speed jet in place
  6. 1

    GLSTA 115 Low rpm idle

    Coils are OEM, Power pack is CDI, will do a Spark jump test. How much jump should I look for? Don't think I messed up the carbs, used oem kits, and engine runs exactly the same as before with the issue on those 2 cylinder's. IS there a possibility this engine has a internal crack or so even...
  7. 1

    GLSTA 115 Low rpm idle

    No I checked that, and it was doing it before I changed the module
  8. 1

    GLSTA 115 Low rpm idle

    I have done that as well, when I pull wire on Cylinders 1 & 3 engine almost quits, when I do the same on 2 & 4 one can tell a difference, but not very strong like the other side and its not enough to die out engine. Did want to mention, Pickup sensor, cables, ignition module are also new, I...
  9. 1

    GLSTA 115 Low rpm idle

    Yes I did that, but there is very little change in RPM's
  10. 1

    GLSTA 115 Low rpm idle

    I purchased a new rebuilt engine by OBR, have done the 10 hour break in. Engine runs fine BUT, it will not hold idle unless I accelerate engine. Once I put engine on 1000 rpm, it will run smooth, but as soon as I pull back on neutral accelerating, engine will drop to 500 rpm and die. Engine...
Top