Search results

  1. B

    2004 merc xr6 150 oil tank question

    just noticed the aux tank on the engine is overflowing (cap is tight) when running and the main tank is only 1/2 full, and she smokes like crazy now until it burns off the plugs. whats wrong?
  2. B

    2004 merc xr6 low water pressure

    strong stream at idle gauge states around 4-5psi at 3500 rpm its reads below 5psi still peeing good stream new gauge took thermostats out no change what could it be?
  3. B

    2008 yamaha F150 no electrical power at the motor

    i have power to the starter and the ground is good replaced the starter relay and nothing, no power to it, no power to the dash, no power to fuse box. all fuses look good too im bumfuzzled as to what could be wrong any advice will be appreciated
  4. B

    gear shift removal

    im pretty boat savvy when it comes to repairs! but this one has me stumped! i need to remove this handle to repair the power trim button, there is a slot at the bottom and usually there is a hex screw on other handles to remove the handle, but i cannot see or feel one on this handle. any ideas?
  5. B

    2008 yamaha 150 no start

    i have 12 volts to the starter, had the starter checked out and all is fine, turn the key and nothing, not even a click, power trim wont work either. all electrical at console works fine, IE depth finder, bilge pump etc. checked all fuses also starter relay? if starter relay, will that keep...
  6. B

    1996 merc 30hp 2 stroke

    will crank up run a few seconds then die, crank back up then die, will do this every time run a couple of secs then die. new fuel pump, new carb kit, new gas tank and hose. not sure where to look next
  7. B

    Used OMC parts supplier

    anyone here have a good source for used OMC parts?
  8. B

    ISO OMC # 0431667 needle

    im in need of part number 0431667 needle (carb) having no luck searching for one goes on my 1973 25hp
  9. B

    PTT problems

    ok, I have the old style PTT pump (external) with the single external solenoid. have a new PTT motor, new solenoid and new PTT switch, still doesn't work!!!!!!!!! see attached and make sure I wired it correctly. thanks
  10. B

    1973 johnson 25 hp one cylinder not firing

    good spark on bottom cylinder, none on top cylinder, new external coils, pulled flywheel cleaned points, turned engine until one side pointed to "set" on the crankshaft, set it to .20 turned motor over to the other side and repeat set at .20. what am I doing wrong? from the back of the motor...
  11. B

    1985 Yamaha 90hp not running right

    carbs have been cleaned with new kits, new fuel pump, new plugs, new plug wire boots, compression is even on all 3 over (118), still just not right, sounds and feels like it is running on 2 cylinders but I know for a fact im getting fire to all 3........... driving me nuts trying to figure it...
  12. B

    1995 Johson 150 fast strike throttle linkage problem

    I have noticed my 150 at about 3/4 throttle (with a hot foot) hangs up, I have disconnected the cable from the hot foot, it operates correctly, I disconnected the throttle cable from the engine and therein lies the problem, however I cannot seem to pinpoint the actual culprit! but it is...
  13. B

    2007 3.0 mercruiser problem

    my 3lt mercruiser is acting up, it will crank right up and idle but soon as I put it in gear and try to throttle up it dies, cranks right back up and does the same thing. this carb does not have a choke, so does it have a TPS? could that be it? fuel is fresh, not sure what else to check. thanks
  14. B

    1992 johnson 225 cooling hose routing

    I found the main hose to the pee tube laying loose and I cant find where it goes, I had the power head removed to replace the steering arm back in may, today is the first day I cranked it, it is then that I noticed no water from pee tube, as well as no water inside the engine compartment, im...
  15. B

    minn kota all terrain 70 trouble

    problem is i only have 3 of the 5 speeds available, so i replaced the speed awitch, no change, still only have the same 3 speeds out of 5 avaialble any ideas????
  16. B

    2000 honda bf90a low compression?

    i bought a whaler with a 2000 honda bf90, cranks and runs, pops on water hose, bogs down when fuel is "asked for" cleaned carbs with some success, checked compression 120, 90 120, and 120 previous owner did tell me that he had "adjusted" the valves could that be the cause for the low compression...
  17. B

    electrical problem

    on my pontoon boat i have a "rocker" switch for the running lights/anchor light down position is for the anchor light/middle position is off and up position is for the running lights the switch is connected to a breaker switch in the down position the anchor light works as it should in the up...
  18. B

    94 Evinrude 150 intruder steam?

    noticed today when i cranked up today as usual i check for water stream, strong steady stream is present after running i noticed steam, still have steady stream of water present. what is the problem? thermostats? what do you think? thanks
  19. B

    1994 Evinrude 150 Intruder question

    i had a friend tell me that my motor with "GL" in the serial number has 175hp carb jets in it from the factory can anyone confirm this?
  20. B

    1994 Johnson 150 Intruder speedo question

    my pickup tube for the speedo is in the foot, it is stopped up with who knows what problem i am having is finding something to "wind" and twist through the tubing - tried air with no result - any ideas? thanks
Top