Search results

  1. W

    Mercruiser 4.3 GM 262 V-6 1996 Manifold

    Can't seem to find an original replacement Mercruiser original Exhaust Manifold. Where could I try to buy online (part 807293A 2 and 807294A 3)?
  2. W

    Merc 25 HP won't go beyond 2.500 RPM

    It is a 2 stroke 2 cyl. engine, the first time the symptom appeared it suddenly lost power as if it had run out of gas ... connected the second tank, went fine for an hour, then the problems came back and are now steady. In the water, the engine will reach 2,500 RPM, but if you push the gas...
  3. W

    RPM Meter (Diagnostics)

    Where can I buy a contactless RPM Meter for diagnostic purposes to use on various Johnson Outboard models to verify the idle and full throttle RPM? Thank you!!
  4. W

    Johnson 35 HP Electric Output

    Measuring the three cables running off the generator (yellow, yellow-grey and yellow-blue) I have measured 12 Volts between yellow and yellow grey above 1500 RPM; approx. 5 Volts at idle speed - no measurements on yellow-blue. Before I buy expensive connectors and rectifiers ... anybody knows...
  5. W

    35 HP Johnson Sea Horse 521 Prop

    Thanks to your help in this forum I have converted the above to short shaft; am running a 14 feet rib, weight approx. 200 pounds plus engine, 1 person and fuel. To begin tuning anybody can suggest an appropriate propeller pitch? My goal is to be able to glide at low rpm and obtain maximum rpm...
  6. W

    Cooling System on J35 521

    Finished my conversion to short shaft, testing the outboard at home; works fine with the cuffs providing water to the water intake screens, not in the tank if water level reaches one inch above water intake screens ... yet working perfect if water level reaches location of the newly installed...
  7. W

    Conversion to short shaft Johnson Seahorse 521

    Have tried to remove the lower unit, spoke to Twin City Outboards and have an offer on short shaft, shift shaft and the like, but what I thought was an extension of the main shaft (4 screws and 1 bolt at the bottom to the lower unit and same connection to the upper foot, approx. 12 inches...
  8. W

    Removing lower unit Johnson Seahorse 521

    Trying to remove the lower unit from a '82 35 HP Johnson (JBAL35CND) I was able to remove all screws from the unit, could pull it down about one inch, had removed all the mechanics connected to the shift mechanism on top, but was not able to remove the axle (where the grease fitting is screwed...
  9. W

    Conversion to short shaft

    I have a long shaft 35 Sea Horse 521 cc (JBAL35CND) that I used on my sailing boat so far; I want to use it with the tender and need to convert to a short (or standard) shaft ... the housing has an extension that can be removed. Can anybody tell me whatI need and where I can get it (drive shaft...
Top