Search results

  1. J

    looper motors ?

    hey guys, i'm fairly new to this site. it,s really helped me out. i know this question probably doesn't belong in this forum and if you need to move it i understand, but what exactly does "looper" motor mean or does it describe?
  2. J

    looper motors ?

    hey guys, i'm fairly new to this site. it,s really helped me out. i know this question probably doesn't belong in this forum and if you need to move it i understand, but what exactly does "looper" motor mean or does it describe?
  3. J

    62 40hp evinrude lu

    hey guys, the other day i decided to reseal my lower unit. from what i've seen on here it would be pretty easy.It was. However, when I got to the part where I had to retighten the bolts on the bottom of the lower unit, the prop shaft seemed like it was kind of tight. When I loosened the bolts a...
  4. J

    62 EVINRUDE 40 HP

    CAN ANYONE GIVE ME THE PART NUMBERS TO THE SEAL THAT IS IN TOP OF THE IMPELLER HOUSING, THE WOODRUFF KEYS IN THE IMPELLAR AND FLYWHEEL, AND THE UPPER CRANKSHAFT SEAL? THANKS
  5. J

    exhaust throb in tell tale stream

    should I have steam and it seems an exhaust throb in the tell tale stream, 1962 40 hp evinrude? i seem to have good water spray.
  6. J

    1962 40 hp evinrude reeds

    are new reeds still avaible for this old beast?can't seem to find any on the internet. how do you know if your reeds are shot. thanks
  7. J

    1962 40hp evinrude upper crankshaft seal ?

    Does anyone know the correct name and part number for the seal that is under the timing advance plate? I have oil getting on my points, coils etc.<br />Also how difficult is it to change? I am relativly new at outboard repair, other than tune-ups and maintenance. This forum has really helped...
  8. J

    1962, 40 hp evinrude lark iv

    need some ideas, went on vacation last week, after about 3 days, the idle got intermittent. One time it will idle smoothly for a while, then it will slow down a bit and idle roughly. kind of like a surge.Give it a little throttle and then idle it down and it is alright. It also got rather hard...
Top