Search results

  1. M

    J100STLESB Max Timing

    Hey guys, I'm still pecking away at the troubles that I bought with this boat. Before the trip to the lake this past weekend I replaced the Rectifier/Regulator assembly, all coils and plug wires. Still having some issues at idle though. I want to check the linc and synch but, I have not...
  2. M

    Replacing Rectifier Regulator J100STLESB, what else?

    I'm pulling the flywheel on this motor to replace the rectifier regulator part. Anything else that I should do while the flywheel is off?
  3. M

    Another Tach and Charging issue. J100STLESB

    I have a J100STLESB, (1990 100GT). I noticed my Tach began intermittently dropping out, usually at lower RPMs. Next thing I noticed was low voltage on the meter in the dash. Some research here led me to believe that the rectifier has gone bad. When I start the engine I do not measure any...
  4. M

    What kicker size for 19 FT Sea Nymph?

    I am wanting to put a kicker on my Sea Nymph 195 GLS. Information that I have found shows a weight of 1800 lbs. I do not know if this includes the weight of the 100 HP outboard or not. Any ideas on how much HP I need for trolling at 2 to 3 mph?
  5. M

    CMC PT 130 Leaking seals

    Has anyone ever tried to replace the hydraulic ram seals on one of these units? Mine is leaking oil from the bottom of the hydraulic unit around the ram. If I could afford it I would purchase a replacement unit, but not in the budget at this time.
  6. M

    Timing mark Pointer

    I have a J100stlesb that I am slowly waking up. Another item that has come up it the Timing mark pointer that is held on with a screw. Mine is loose. Before I start the Link Sync procedure I need to get this positioned correctly and tightened down. So, do I just pull a spark plug and use a...
  7. M

    Waking up a J100STLESB Issues

    I bought a 19' Sea Nymph GLS last year that had not been used in a year, so probably two years since it ran. Just getting this one going again may take some time. I rebuilt the carbs very carefully. Each passage was checked for flow as it went back together. I installed a fuel water...
  8. M

    Trim tilt compatibility?

    I'm looking to change my 1992 Evinrude TE40ELENM from tilt assist to power tilt and trim. What are the year models that I could look at for doner parts?
  9. M

    What psi Compression?

    I just purchased a boat (cheap) with a 1992 Evinrude 40 HP. Model is TE40ELENM and has the VRO system on it. The motor has no compression on the bottom cylinder, the top is 119psi. I would like to know what the normal compression would be for the cylinders for a motor with about 200 hours on...
Top