Search results

  1. S

    1990 Yamaha 200 ETXD no spark!!

    Good afternoon everyone, my 1990 200 has overall been a great motor. Few issues here and there that I’m usually able to fix. Last few trips out I realized that my batteries were not charging. Upon further inspection of my rectifier I noticed the red wire at the connector broke. So I planned on...
  2. S

    Anyone know which hose

    My seastar steering hose started leaking. I emailed seastar and they think it looks like a “regular” hose. It’s only about 5 feet long and they connect to other hoses that run to the steering wheel. I’ll post pictures.
  3. S

    Leaking hose

    So I finally replaced the shift shaft on my 1990 Yamaha 200. Everything is going great until I notice one of the hoses for my Seastar steering is leaking thru the worn part of the hose. I know the best bet is to replace the hoses. However is there a way I can make a repair to get me thru the...
  4. S

    Drive shaft bearings?

    so I’m replacing the oil seals on the driveshaft. The bearings came out and I’m having trouble getting them all to stay in. Does anyone have any tricks to help them stay in until I can install it? I know some use Vaseline when installing the bearings on connecting rods. Can I use that? I’ll...
  5. S

    Shift shaft

    What’s up guys. Lately my 1990 Yamaha 200 ETXD has been running great. However the other night I ended up needing a tow in. Started the boat to move spots and put it in forward gear and there was a slight grinding noise almost sounded like if you slowly advance the throttle and it grinds. It...
  6. S

    Please help

    Hello everyone, I have a 1990 Yamaha 200 ETXD. Last year I bought the boat and the motor ran absolutely great. I was shocked actually at how well it ran at all RPM ranges. WOR was about 5400. Towards the end of the season there was some bogging at 1200-1500 rpm. A few times it would stall but if...
  7. S

    Short in ignition

    Last year I replaced the 10 pin harness that connects my 1990 Yamaha 200 to my ignition. Now sometimes my ignition will have no power. Some of the wires are frayed. I can’t find the same ignition that I have currently ( plugs into the harness) does anyone have any idea what I can do the fix...
  8. S

    Ignition help

    So I started to replace my boats electrical panels. I added a new ground bus bar and a switch panel. I know my ignition was working before I started but now everything else works and I have no power to my ignition and both trims at the helm and on the motor. I have power at the male end of the...
  9. S

    Electrical issues

    I have a 1990 Yamaha 200 two stroke. I recently replaced the steering bracket. I had a post for my broken quick connect plug but I wanted to start a new one. Everything was working great up until then. I accidentally ruined the 10 pin harness and decided to hard wire it back together. Long story...
Top