Search results

  1. Powdershredder

    Tilt and trim unit for 50hp Johnson.

    Does anybody know if a tilt and trim unit from a mid 80’s 70 HP Johnson/Evinrude 3 cylinder will fit on a mid 80’s Johnson 50 HP 2 cylinder engine?
  2. Powdershredder

    1976 Evinrude 35hp. Spark follows the same spark plug.

    Ok so I’m having trouble with this 35 Evinrude. I’m only getting spark to the exact same spark plug. I’ve tried moving this plug from cylinder to cylinder and interchanging all electrical connections from the points and the coils. All combinations provide spark but when I use any other spark...
  3. Powdershredder

    89 Pro 50LF Prime Start

    Can anybody tell me where/or what specifically the blue wire on the Prime Start Solenoid is supposed to connect into? Thanks.
  4. Powdershredder

    1989 Yamaha PRO 50LF water intrusion Cylinder 3

    Looking for a few ideas as to why I may be having water intrusion on cylinder 3 on my rebuilt Yamaha PRO 50LF. Compression test reads 120 at all 3 cylinders and all 3 cylinders have good strong spark. The motor will start and run fine until it kicks into low idle at which point it begins to...
  5. Powdershredder

    1989 Yamaha PRO50LF Electrical Connection?

    Can somebody tell me what this connection is for. I just completed a rebuild and am now working on th electrical and I can not figure out what this plug connection is for. Thanks.
  6. Powdershredder

    89 Pro 50LF

    Hello, looking for some help with a PRO 50LF I’ve been working on. It’s a 2 Stroke oil injection and I am confused with the seleniod that is attached to the bottom carbuerator. There are two wires coming out of the top one blue and one black. I’m assuming the black is a ground but have no clue...
  7. Powdershredder

    Early 70’s Mercury 650 Stator

    Hello everyone looking for some info. on testing a stator on a early 70’s Mercury 650 3 cylinder. I’m not getting any spam on this engine and am going to start testing each of the electrical components to see if I can pinpoint the issue. Does anybody know the proper way to test this stator...
  8. Powdershredder

    1979 Johnson 70HP Rectifier overheating.

    I’m having trouble with the rectifier on my 1979 70HP Johnson Outboard. The rectifier is overheating and melting the epoxy out of the back side. It seems to be charging the battery excessively at high RPM’s 15-16volts. The flywheel also seems to be pretty warm after use at higher RMS’s which...
Top