Search results

  1. N

    BF 50 Tachometer

    Can any one tell me how to hook up a tachometer to a 02 Honda BF50? I have the harness and new tack but can not find the plugins. Thanks
  2. N

    Honda BF50 Paint Code

    I just finished repairing the chips in the hood of my 2001 BF50 and had it painted at a local body shop. Theys used a scanner to get the color. Th hood is well painted with base/clear coat but is much lighter then the rest of motor. Does anyone know the paint code? Thanks
  3. N

    Honda BF50 Tach Installation

    Could someone please give me some advice on hooking up a RPM gauge on my 2001 BF50? I got a gauge from the dealer here in town which has three wires, grey, black and yellow, and black for the actual guage. The light wires are red/white and black. I am not sure where these would blug in for...
  4. N

    Honda Decals

    Can Anyone tell me where I can get a set of Honda BF50 decals made up? I am redoing my hood and need new decals. Thanks again.
  5. N

    2003 Yamaha T50 vs 2001 50 Honda

    I am looking at purchasing a Honda 50 four stroke or a Yamaha T50 High Thrust for my 16 foot Lund Stalker. I built a front deck and installed a trolling motor spare battery and 13 gal fuel tank in front. The Honda only has one season on it. Any recomendations? Pros & cons?
  6. N

    Yammaha T50 or Honda 50

    I am looking at purchasing a Honda 50 four stroke or a Yamaha T50 High Thrust for my 16 foot stalker. Any recomendations? Pros & cons?
  7. N

    Miss in F40, 2004

    I have a miss in my F40 4 stroke. While at 3/4 to full throttle after running for a few minutes I get a miss in the engine. It only hapens once and a while and sometimes worse then others as if the engine dies for a split second. I already had it in yesterday for a carb cleaning and it is still...
  8. N

    Yamaha F40 Painting

    I recently sprayed the lower end of my 2004 F40 with Colorrite- matched paint (Spray Can). Prior to application I ruffed up the surface for paint adhesion. After a couple of days some of the paint began to flake off right to the primary. What would of caused this?? How should this be repainted...
  9. N

    2004 F40 Trim

    I have a 2004 40HP 4-Stroke yamaha with Gas assist and am looking for help on setting the Trim. After reading the manual it said that I can set the trim simply by flicking the trim lever up while stopped, lift the motor to desired trim, and lock the lever in the down position. The mechanism...
  10. N

    twin tanks

    IO am planning on building a raised platform in the front of my Lund Stalker to offset the weight of my new Yamaha F40. I am also plannining on placing the gas tank below the floor.<br /><br />I was wondering if I could run 2 plastic 5 galons together by splitting the line instead of buying a...
  11. N

    2004 F40 Tach Wiring

    Can anyone tell me how to hook up the Yamaha tach with oil and temp lights to my 2004 40HP 4 Stroke? The dealer wired in the tach but never wired in the temp or oil light warnings.<br /><br />Thanks
  12. N

    2002 25HP 4 Stroke

    I have a 25 HP Yammaha 4 Stroke, tiller, electick start, long shaft. This motor is in mint condition and I was wondering how much I should be asking for it. I am looking at upgrading my package. I am thinking $2350.00 cdn funds. Any suggestions?
  13. N

    HP Rating

    Could anyone tell me if the HP rating for a 1985 20HP Evinrude Short Shaft is rated from the HP from the pwerhead or prop?<br /><br />Thanks
  14. N

    25HP 4 Stroke

    Hello.<br /><br />I just purchased a 2002 25HP 4 Stroke Yammaha packaged with a 1997 16 ft Lund Stalker. I tried it out today in extremenly windy conditions with large waves and I could not get it trimed out well. It had a hard time getting out of the hole. I had one notch left on the manual...
  15. N

    Legend V1468

    I am looking to buy a new Legend V-1468 (14 foot deep/wide)but don't know much about them.<br /><br />Can anyone tell me if they are a good buy, how do they compare to 14 Lund?<br /><br />Thanks
  16. N

    Evinrude Transom Bracket

    I am seeking a used manual tilt transom bracket assembly to fit a 1985 20HP Evinrude Outboard.<br /><br />If anyone has any ideas of where I may locate one could you please send me the links. I have exausted all my sources trying to locate one.<br /><br />Thanks
  17. N

    20HP Evinrude Fuel Delivery

    I began to replace the fuel lines on my old 1985 20 HP Evinrude and ended up only replacing a the main intake hose from the housing to the fuel pump. I will have to order lines for the carb and engine block as where we live there is little in the way of supplies. I am not sure what size the line...
  18. N

    20HP Evinrude Fuel Delivery

    I began to replace the fuel lines on my old 1985 20 HP Evinrude and ended up only replacing a the main intake hose from the housing to the fuel pump. I will have to order lines for the carb and engine block as where we live there is little in the way of supplies. I am not sure what size the line...
  19. N

    Top Seal Replacement

    1985 Evinrude 20HP Rope Start<br /><br />I noticed that the area just below the flywheel becomes a little wet after running with fuel. Would this be a sign of the top seal needing replacement.<br /><br />How difficult is this to replace and what are the steps required. Any help is greatly...
  20. N

    Spark Plug Gap/Fuel Economy

    I was wondering if anyone can tell me what the GAP Setting is for the spark plugs to fit a 1985 20HP Evinrude?<br /><br />Recently I the motor started acting up at take-off. She spitted and sputtered, serged, until finally reving up to speed. After I took out the spark plugs I noticed that one...
Top