Search results

  1. Dawson130

    115 mercury tracker 2 stroke. Running issues

    Recently brought it to a shop and it sat there for a month. They told me 2 of the hoses were swapped on the accelerator pump. Took it out on the lake and it ran great I shut the motor off to start fishing. About 20 mins later I tried to start it back up and it struggles to stay running. Won’t...
  2. Dawson130

    95 merc 115 tracker pros series. Help w 2 blue wires under oil reservoir??

    Just recently bought this motor. Going through it the other day and noticed two blue wires coming from under the oil reservoir. Not sure where they need to go as it seems previous owner cut them. Any help is appreciated. I attached a photo below!
  3. Dawson130

    Please help! 95 merc 115 hp

    So I just purchased a 95 nitro bass boat powered by a 115 merc. Took it out today and motor was really hard to start and have taken it out 3 times now. Motor seems to lack power. Haven’t been able to get it on a plane and when it is running it’s been coughing a lot. Long story short i found a...
  4. Dawson130

    help please!

  5. Dawson130

    help please!

    I just bought this motor and the guy was using a long bolt for the tilt pin also discovered it was not pumping water. Pulled the hose out and just a tiny stream coming out of fitting on block. Assuming it would be a bad impeller. Any links on where I can find a kit for this. Seems like a pretty...
  6. Dawson130

    quick question!

    Where is the cavitation plate is it the one right above the prop?
  7. Dawson130

    Johnson 20 hp 1967. Need help!

    have a Johnson all new ignition system but is very hard to start. The cam follower is not riding on the guide under the flywheel so the butterfly in the carb won’t open. I’m assuming the hard to start problem is because of a fuel issue. It will try to start but only runs for a couple seconds...
  8. Dawson130

    Help please!! 98 evinrude 9.9

    Just picked this motor up the wires from the stator are pretty fried so have to replace that. Where can I find that part and also what size bolts do I need to use to pull the flywheel off
  9. Dawson130

    Help please! Johnson FD-21R 67 20 hp.

    Pulled the flywheel off and replaced wires and plugs, cleaned contacts. Entire ignition system looks brand new. It is hard to start and when it is running the fuel smell is really rich and will only stay running in fast position. The odor is so strong within 30 seconds of running my eyes will...
  10. Dawson130

    Help please Johnson FD-21R 1967

    I recently picked up a 1967 20 hp Johnson FD-21R. I started it up and ran it in a bucket. However I do not see any water coming out of the engine is there a P hole somewhere or does it all come out of the bottom exhaust port also there was like an oily film over the top of the water when I was...
Top