Search results

  1. K

    Ignition Coil wiring help

    For starters the my back story. Purchased used boat with Yamaha stern drives as a project. The coil packs were bad so I figured my easiest and cheapest alternative was to losses the YEMS engine management system and go with the simple dizzy and ignition coil and new gauges. Igot everything...
  2. K

    Dock repairs

    Soooo, I want to repair the dock. I will need a barge to complete my project. The excavator is 1800 lbs so the smallest spud barge I can find will do 60x24. Will I need a Captain to move the barge if it's my barge??? If this goes well I may look to work for profit in this field for a the...
  3. K

    Yamaha stern drive 4.3l replacement

    Ok well the boat made it thru most of the season. With a ton a help from the experts on this forum. Now I have another question. I was not getting much power from the starboard motor. Idled good and ran under load but with a load won't get past 2500 rpm. I rebuilt the carb because the...
  4. K

    Yamaha shift interior switch/platr

    Hello all, Hoping you guess can help me out on this one. I'm looking for a Yamaha shift Interrupts switch for a Yamaha sterndrive. Part # 6T0-8259F-00-00 Or any suggestions on a work around.
  5. K

    No power at ignition wire

    First off, thanks for the help with my Yems trouble. I ended up swapping that mess out as you guys reccommeded. The swap went good got it running and the timing in order. I had to get new tachs as they ran through the yems computer. While installing the new tach went to check the port motor...
  6. K

    92 mercruiser 4.3l 6t2 no spark

    Hello all, well When I purchased the boat it had spark in both motors and would fire. Took it home a set to work getting the power tilt and trim and trim tabs fuctioning with a bit of help from the forums. I also cleaned a few connections, checked fluids and impeller. went to start the motor...
Top