Search results

  1. M

    Evinrude E25TECSSA water pump

    I took the Lower unit off to replace the impeller, but it was not bad. When i start the motor back up i get water for a few minutes then it stops...<br /><br />Any ideas?
  2. M

    what year is my evinrude E25TECSSA

    I went fishing with my buddy and his motor quit pumping water and got hot so we shut it down. I'm going to replace the impeller but don't know what year the motor is.<br /><br />Model: E25TECSA<br />Serial: E0001531<br /><br />also, on the right side of the shaft there is a plate with 2 3/8"...
  3. M

    Honda B75 short and B100 long

    If these 2 motors are the same year...<br />Does anyone know if i can swap short for long?<br /><br />Both motors mid 80's, i'm looking to buy the B75 just for the shaft.<br /><br />Thanks
  4. M

    1968 MERC 9.8 Water out the Exhaust?

    I have never noticed water comming out the exhaust holes at the back of my motor, at the top of the exhaust leg. Is this normal? I just put a new impeller and the nylon washer at the bottom of the powerhead/top of the copper tube from the water pump. Also replaced the gasket between the...
  5. M

    CARBURETOR Merc 110 9.8

    I have a 1968 Merc 110. Serial 2472553. It starts and runs ok/good but when I "run" at top end for a while (getting to the fishing spot) and come back to idle speed it runs like crap and dies. If I baby it for a while (15 minutes +-)it will idle. Then if I run again I get the same thing. <br...
  6. M

    Honda B100 cooling question

    My B100 has what appears to be good water flow but still over heats and seizes, the motor will not even pull. I can start it again after 20 minutes or so but it will seize up quickley.<br /><br />divebobber had a simillar post on 11-28 but i didn't see any conclusion.<br /><br />Any help would...
  7. M

    1968 mercury 9.9

    Can anyone tell me where to put oil in the lower unit? Is it the plug on the front right side of the lower unit? and if i take out that plug what should come out?<br />I think i have abused the motor and need to give it somw TLC.<br />Also, there is a plug that has "FLUSH" below it. Whats that for?
  8. M

    My B100L

    I have no clue what year but would guess late 70's early 80's SN: 1402778.<br /><br />I have no spark! I took off the round thing with the maginets and looked at the ?stators? and all looks well (clean and dry). Someone told me to replace the CDI. (the thing the plug wires come off) if this...
Top