The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
Hey there, I have a 1992 capri 18' and was working on it before the season gets going full bore. I was going to go around with a grease gun like I used to do with with my old 1967 mercruiser 120 but I found only two zerks on the trim pivot and none on the steering pivots on the outdrive, is...
I just bought a 1991 bayliner capri with a 3.0L alpha one. To replace my 1967 seaswirl with a mercruiser 120.
Now I thought just the refinements in engine design and the 1/2 litre in displacment would make it pull better but it is a little slugish. It will pull me up on the wakeboard OK with...
Hey there all,
I'm looking at a 1984 reinell 19' with an OMC outdrive and chevy 305 V8.
I own a mercruiser and have rebuilt 3-4 volvo uppers for freinds but have never had any experience with the OMC's. So that's were you all come in, I need some help with this before I drive 173 miles north...
Hey all,
I noticed when I drug the old girl out that there was gear oil in the lower portion of the drive ( were the exhaust and cooling water exit ).
I searched the forum for such things and found that it could be a couple things... shift shaft, water pump seal, or prop shaft seal.
Now...
I was wondering if anyone has a link to info on porting my own prop?<br /><br />Is it worth it? I have a 1967 seaswirl 18' with a perfect running mercruiser 120 i\o it run's good but could use a little more omf off the line when towing. I read a few things on this site before about doing this my...
OK since my boat now runs awsome (thanks to all whole helped me last fall) I thought I would come back and see if you all could help once more. <br /><br />It's time to get things ready for the summer and I'm going to change the oil this weekend, only trouble is I don't want to drive to a "boat"...
I read an article about drilling a small 1/4" hole at the leading edge of the blades through the hub. The idea was to allow exhaust gases to pass through the onto the blades allowing it to slip a bit off the line. <br /><br />I have a 1967 seaswirl w/120hp merc I/O, and what I can only guess to...
The title says it all, I have a 1967 seswirl, it's my first boat and would like as much info as possible, performance specs new, how it ranked for it's era you know just genrele info.<br /><br />Does any body know any thing about these old boats?
I bought a Doel fin last night and when I got home I was checking it out and the directions are vague as to where to mount it fore to aft. <br /><br />What do you think should I mount it towards the front, or the back or right in the middle.
I have 1967 seaswirl with a 120hp merc I/O. I just bought this bought from my father and he had the same problem.<br /><br />I took it out the other day and it ran well but sluggish, on the way back to the launch with the throttle barried the boat had a suge of power and ran well for a while. I...