Search results

  1. J

    FWD pump

    Hi I've had a Donzi 255 1996 for three months not used on water yet, I found today there is water below the floor in the FWD cabin, there is pump (not automatic I think) it looks like there is no connection with the bilge because it is completely dry when I try the start I heard a signal and...
  2. J

    steering hose replacement

    Hi guys, just need to know if the replacement of the called low pressure hose in my steering requires a bleeding of my steering system, do I have to?
  3. J

    shore power inlet

    HI, mine is a Stingray 200CS, it doesn't come with AC capability and I'm willing to install AC power in it, where do you think could be a good spot to place the Shore Power Inlet?
  4. J

    Question About Mixing Hbird, Lowrance and Garmin Transducers

    hi fellas this could sound a little weird. I need your opinion. my boat Stingray 20' has a Huminbird sonar HD 600 and a fishfinder Lowrance so I have two sensors in my transom one each side, now I purchased a Garmin GPS sonar combo, another sensor, my question is witch one do you recommend...
  5. J

    Risers

    hi, if I want to include 3" risers in exhaust system to make probability even lower getting water into my MCM 305 engine, do I need to change any other stuff in addition to risers, studs and gaskets?
  6. J

    Shift Cut-Out Switch

    Alpha Models Are Equipped With A Shift Cut-Out Switch, can anyone explain in detail how this switch works in relation to the ICM? best regards
  7. J

    Trim system

    can the Trim system be tested even when the drive is not installed?
  8. J

    starter wiring

    Can somebody explain what function has the purp/yellow wire from the OIL press switch (the same to the fuel pump) coming to the starter?
  9. J

    ICM

    Hi, can the ICM be bypassed for troubleshooting purposes?​
  10. J

    Ignition coil

    Days ago I purchased one similar to mine in autozone, it came with a label ...use with external resistor... And I was recommended to take it back. Now I received the exact replacement from Sierra and has the same label. Use with external resistor except when it's used with thunderbolt ignition...
  11. J

    Water hoses

    Hi Guys... The manual does not say anything but ... Can we use perfect seal in water hoses from thermostat housing and recirculation pump??? Someone recommended me to do it. Thanks
  12. J

    Mercruiser harness

    according to part list the PN of my engine harness is 862173T1 and similar 84-862163T03 any schematic for connections? thanks
  13. J

    2001 305 CID

    Hi I'm rebuilding my engine and have some doubts about where to place alternator bracket. Mine is at your upper left if you see the engine from inside the boat. Alpha Configuration can anyone has a picture or procedure to install this alternator, thanks
  14. J

    what to do..

    Hi I'm new at this, I'm rebuilding my engine Mercruiser 305, when be finished I pretend to run it for testing before put it in the boat, what can I do with the power steering pump? rgds
Top