Search results

  1. O

    carb adjustment

    1996 evinrude 25 hp 3 cylinder.could someone tell me if screw on carb on side thath says in motor diagram valve needle .is this the air screw for rich and lean adjustment. thank you
  2. O

    engine sputtering on takeoff

    1996 evinrude 25 hp . 3cyl.Took my boat out after lon g winter ran good trolling for 3 hours then went i went to go to wot it sputtered and sputtered then it was ok. did not do it again next time out on lake.is it just dirty carbs after sitting all winter or could it be something that would...
  3. O

    to much smoke

    My evinrude 25 hp motor when trolling in low speed smokes a lot and also every once in awhile there is also drops of gas and oil that come out of exhaust and fall in water cause i can see it.Wich way do i turn air screw to remedy this in or out. thanks in advance.
  4. O

    1985 Bf75 Idling

    I would like my 7.5 to idle slower for trolling. I have adjusted idle screw to it lowest that lets tiller handle go lower. Just on top of that screw on carburator there is a screw wich i beleive an air screw do i turn it in or out to idle slower and not damage engine. THANKS IN ADVANCE
  5. O

    25 3 cyl power pack or flywheel sensor

    evinrude 25 hp 3 cyl. 1996 when you roll it kick with electric start it does not fire but when flywheel slows down it will spark.Since there is no return on electronics would somebody have had this similiar problem and know wich one it is power pack or sensor under flywheel . thanks in advance
  6. O

    evinrude 25hp 3 cyl wont start

    I was on fishing trip engine ran good thursday and friday. Saturday mornig engine started fine when i gave it gas i went about 500 yards and engine quit. It would start up good idle for 5 seconds then quit. Did this many times.Put 3 new plugs same thing .My fishing trip was cut short.There is...
  7. O

    honda bf 75

    I just bought this outboard. It is a 1985 and runs well. I changed the oil in it and was wondering if there is an oil filter and were to find it. THANKS IN ADVANCE
  8. O

    idling setup

    hi, my 25hp evinrude idles fast so as when i am trolling boat moves to fast.i tried adjusting screw on linkage that lets me turn motor handle to lower speed.when i do this motor idles slower but after about a minute motor starts to idle rough and stops.a friend of mine told me to turn carburator...
  9. O

    idling too fast

    i have a 1996 25hp 3 cyl. evinrude. the problem is it idle fast so as to when i am trolling the boat moves to fast. i adjusted the screw where the motor handle will go further to slow speed.it works until about 1 minute after the motor starts idling rough and quits.any suggestions thanks.
Top