Search results

  1. P

    Motor Bounce in Reverse

    I purchased a used Pontoon several years ago with a '87 60hp Mercury. At the the time the trim tilt/trim were not electrically operational and a piece of allthread was used to keep the motor in place ata a specific angle of sorts. I decided to fix the elecrtrical system by installing a three...
  2. P

    '87 Mercury Water Pump

    No water at idle however solid stream at WOT. How difficult is the pump to change? Any tips?
  3. P

    Bass Buggy Trailer Tire Size

    Does anyone by chance know the tire size for an 88' bass buggy trailer? I have tried to locate the leak, used green slime, submerged the inflated tire, soapy water, etc but it does not leak until there is a load on the tire. I figure I can fix this by installing an inner tube but the boat and...
  4. P

    Tubing Question

    Just got my 86 Bass Buggy w/Mec 60hp running after ywo years of sitting. Peviously used for fishing. Family now wants to use for tubing. Assuming 3 young adults on board and one on the tube, will the toon pull the load???
  5. P

    Replacing Stator(s)

    After reading the numerous posts regarding stators I have reason to believe my stator needs replacing due to the following: battery no longer charges and motor will not idle. My question is can the stator be replaced while the boat is still in the water?<br /><br />'88 Mercury <br />60hp<br />sn...
  6. P

    Electrical Schematic

    Hello all. Is there a site where would can get a schematic/drawing/block diagram or such that would help me understand what is involved in the ignition system of my '88 Mercury ssn OB308702. I'm trying to relate the boat's ignition system to a car's ignition system. As always thanks for any help...
  7. P

    Impeller Replacement

    While I'm waiting for my motor manual maybe a few questions can be asked. Can the impeller be replaced while the boat is in the water (close to the bank where I can wade)? I suspect water in the fuel tank since it is starting to run rough for no apparent reason. I was going to empty the tank and...
  8. P

    Mercury Motor Manual

    Need some opinions please. I have an '88 60hp Mercury. I have seen the Seloc manual advertised here on this site. I have also heard these manuals were so so. Does Mercury sell a manual? Are there manuals other than Seloc and if so how do they compare and where can they be purchased? Thanks...
  9. P

    Gas Tanks

    This will probably be an opinion question but I hope to share some of your experiences. Which tank is better to us for my pontoon plastic or steel. I believe I'm getting a water in my gas via the vent plug or condensation.
  10. P

    Motor runs poorly... wire not connected??

    Hello team, I've posted last week about my 1988 60hp Merc (sn OB308702) not idling any more. I was told to check plugs/wires etc (basic T/S approach) however I have not made it back to the lake yet to check. Any way I was thinking about something. The last time out when it did run good I removed...
  11. P

    What went wrong???

    Two weeks ago my 60hp Mercury (mounted on a pontoon boat) was peforming excellent. It normally idles at 1000 rpm. However today it idles for a couple of seconds at approx 800 rpm and then dies. When the trottle is increased to keep it idling the motor rpm's increases and then falls back. I...
  12. P

    Pontoon Lighting

    I want to replace my removalable battery operated stern white light with a perament light. I found a light that can be swung out of the way when not in use. However it is shorter in height by about 6". As I understand it the stern light needs to be a meter above the side lights and out of the...
  13. P

    Potential Water Flow Blockage

    This week I navigated in about 2' of Alabama backwater. I noticed I was churning up a lot of muddy water. I have read some postings about pump problems that may be caused by blockage. My question is how can I determine if I my have some blockage. The motor appears to performing at its top end...
  14. P

    Replacing Bottom & Side Bunks

    I've read some posting regarding DIY bunk replacement. I have a fiberglass 16' Stratos. I will be using a scissor jack from the truck. I plan on putting a piece of plywood between hull & jack (one side at time). WIll the boat become unstable. DO I have high risks? I don't have the comfort of...
  15. P

    How fast is too fast

    After extensive detailing I finally put my 1990 60hp Stratos/Erude onn the water. I bought this boat used in 1993. Excellent shape then and now. For the most part I ran the motor wide open (approx 35mph/5500rpm after trimming) open to get from point A to B. Never thought much about speed until...
  16. P

    Louder Warning Beeper

    Let start off by saying thanks to all the responses to previous correspondence's I have posted. This is truly a great forum. Now to my question... I have a 60hp Erude. I noticed others have made the comment about the low/no oil, fuel, temp alarm not being loud enough while on the water. True or...
  17. P

    Trailer Serial Number

    Does anyone know where the serial number is located on Stratos Trailers? My insurance company requires thius info. Thanks... :confused:
  18. P

    90 Evinrude Warning Buzzer

    A month ago I had the motor worked on due to not using the boat for about three years. Mechanic said just general carb cleaning. I then worked on cleaning/detailing a month. Well todayI decided it was time to put it in the water. Before I left the driveway I did a quick check. I noticed that...
  19. P

    Anchor Rope Length

    I have a bass boat. About how long should the anchor rope be? :confused:
  20. P

    Boat Motor Cowling Clear Coat

    I recently removed the paint from my Evinrude motor down to the gel coat. I painted using Tempo zinc chromate and with four coats of Tempo marine paint. I let it dry for a day and than sanded using 800, 1000, 1500, & 2000 grit wet/dry paper. The surface is smooth. Someone mentioned I should...
Top