Search results

  1. J

    95 Evinrude 90 Crossflow Help !!!

    I'm at my wits end with this motor. I've been struggling with an intermittent ignition problem for over a year that I can't solve. I take the boat to the local lake and she runs fine. I haul it off to a trip to the coast and it gives me problems. Ruined to seprtate trips. The trouble starts when...
  2. J

    Should I be concerned ?

    First off, thanks for the helpful replies with my project. I just finished a first time rebuild on my 95 Evinrude 90. I fired her up this morning and seems to be running fine except the idle is around 1000 RPMs on the ear muffs. I am running 25:1 in the tank and have not had the throttle and...
  3. J

    Bolt torque problems: advice or help please

    I am reassembling my 95 evinrude 90 and I can't even get close to some of the torque specs without the bolt feeling like its starting to strip in this soft aluminum block. I think the crankcase flange are 60-80 lbs, bearing retainer plate screws 120 -145 and crankcase heads 120-145??? I am...
  4. J

    Rod Bearing Questing ?

    One of the cages on a newly installed rod bearing skips a little on a 95 Evinrude V 4. Is this ok or normal or do is need to try to realign the rod caps?
  5. J

    Just a little advice please

    Hello all, I am into my first rebuild on a 95 Evinrude 90 crossflow. Things are going well so far but I am a little confused about a couple things. First what is the orientation of the crankcase seal ring gaps? I believe the manual says to face them down but I think Iv'e read on the forum to...
  6. J

    60 or 90 degree crossflow ?

    Can anyone help me out with what motor this is E90TLEOR Go3868334. I know it is a 1995 90 HP crossflow but i'm confused if it is a 60 or 90 degree motor. I believe I read somewhere they made the 90 degree up until 95 and started making 60 degree in 95 ? Any help would be appreciated.
Top