Search results

  1. S

    Anti siphon valve

    E10 gas caused tank debris to clog up the anti siphon valve mounted at the pickup on a belly tank. I wound up removing the valve. the boat is a center console with a sx250. do i need to replace or can i get away without. thanks,
  2. S

    2000 ox66 sx250tury runs out of fuel /2000 edgewater

    thought i was just dealing with e10 issues. i mixed 75 gallons e 10 with 25 gallons mtbe. going through 10 micron yamaha filters every 2 to 3 hours. bulb would be collapsed so assumed clogged filter. finally drained tank and started fresh with new e10 with ring free and stabil. same results...
  3. S

    2000 -- 250 OX 66 temp & pressure guages

    All set.
  4. S

    Water Temp & Pressure Guages

    Have a 2000 250 ox66 and want to install Yamaha water temp and pressure guages. Any tips on how and where these (senders) install would be appreciated.<br /><br />Thanks
  5. S

    250 sw 2 ox66

    Is there a trick to removing the impeller key from the shaft? Played with it but not budging.<br />Thanks.
  6. S

    Winterizing 250 ox66

    Having a hard time finding Yamaha fogging oil and fuel stabilizer at auth. dealers. Manual warns against using fogging oils that contain Lead, Silicon as it will harm o2 sensor. Any suggestions on substitutes. Yamaha claims no need to drain fuel at motor if you use they're fuel stabilizer. Will...
  7. S

    Yamaha tilt / starting problem

    Have a 2000 250hp OX66 saltwater series with low (40) hrs. Recently developed a problem with the tilt and also when trying to turn the engine over. Clicking noise in both cases. Guages dim down and battery voltage drops. Batteries are new and fully charged. Almost seems like a short or relay...
Top