Search results

  1. B

    Suzuki dt 200 no spark too my cylinders

    It's a1998 dt 200 and I have no spark too any cylinders it turns over fine I have eclectic fuel pump working correctly. And power trim is working fine I'm looking for causes of interrupting the spark I have ordered a manual but am trying too familiarise myself with potential causes that will...
  2. B

    Help needed on switch continuity

    #2 Today, 08:08 PM Should the kill switch. Neutral switch . Oil solenoid and low oil reset circuits all be closed circuit for engine too have a spark and I should have continuity in both wires of each switch ??! Thanks
  3. B

    Suzuki dt200 1998

    So I have the engine all wired up I have trim and tilt working fuel pump working and an intermittent bleep from controls the engine turns over but I have no spark too any plugs where do I go next too check wiring faults what could prevent a spark and how do I test and eliminate
  4. B

    suzuki dt200 efi

    Can anyone send me a link too a wiring diagram for the above engine just rebuilt engine and I'm struggling with loom connections
  5. B

    Mariner 200 hp offshore

    Hi there does anyone have a link for a manual. I am rebuilding my mariner 200 hp v6 two stroke offshore serial number 9518131 not sure of year thanks in advance rob
  6. B

    Gearbox I f@@ked up

    whilst giving my mercury 100hp 2 stroke 4 cylinder a severe service and maintenance check i removed gearbox to replace impeller and found the water pump bolts were corroded and were gonna break off after soaking them and moving them forward and back I eventually removed all six with no problems...
  7. B

    Mercury 200 offshore scored block

    I have just purchased a mercury 200hp outboard as a non runner project the condition is like new but has had piston failure and has marked the bore I have a replacement piston and rod but have been told that I can replace the liner rather than re bore or hone is this correct can I buy a liner...
  8. B

    Can anyone help with mariner 3 cylinder 75hp wiring

    Hi there I am iin need of wiring diagrams for a 75hp 3 cylinder mariner outboard serial number 9530342. I was sent a link to a compressed manual which was very helpful but the only wiring diagram showed an engine with no low oil module wiring on it I have a low oil unit with. Dark blue...
  9. B

    mariner 75hp 3cylinder 2 stroke con rod torque settings requied asap

    I have my 1988 3 cylinder 75hp engine in bits just put crank and pistons back in but am now stuck as I don't know torque settings for con rods and head too block bolt settings many thanks
  10. B

    5.0l Efi 1998 bravo. What transom and drive ratio do I need

    I have a 1998 Mercruiser 5.0 bravo engine that I am fitting in my 18ft regal speedboat that originally had a 3.0 v6 engine and drive I have the engine and have been offered a brand new never fitted transom assembly and gimble with rams it's a mercruiser alpha one gen 2 transom serial...
  11. B

    Mercruiser 5.0 mpi bravo help with wiring needed

    Hi there I'm new too forum and am in need of advice I have a mercruiser engine listed above it is complete and was running until I removed it from boat hull too fit y pipe as original owner had thru hull exhausts. But whilst engine was out of boat the goats in the field have chewed. The harness...
Top