Search results

  1. W

    1988 200XP engine alarm

    My alarm comes on when I am at, or near WOT. If I back off a little it shuts off. I have heard it might be low fuel pressure(clogged filter) but not sure. I pulled the inline filter and it does have some junk in it. I have an hour drive to the lake, just to check if that is what it is once I...
  2. W

    Not good when the tractor shows up at the ramp!!

    I took these pictures a couple of years ago after finishing up a walleye tournament. We were all sitting around telling fish stories while quenching our thirst and watched this disaster take place. We saw it go in, just did not have a camera in time. 2nd picture: Owner of truck walking into...
  3. W

    200xp won't turn over

    The cranking selinoid on my 1989 200xp makes the clicking noise followed by some "hissing" when I try to start it up. I have replace the selinoid and same thing. I have 12.8 volts coming into the selinoid, but don't get anything out when cranking. The switch lug(small one) shows about 5-8...
  4. W

    1998 75hp won't run

    This engine will not start even after it has been running for several minutes. The only way to get it started is to put some fuel into the carbs while cranking. It runs fine until it is either put into gear, or shut off then it will not start again.<br /><br />Any suggestions as where to start?
  5. W

    1989 200XP Compression numbers

    After doing a decarb, I checked the compression on my Rude and found that there was not much difference between cylinders, just they all seemed low. Can someone tell me what the compression should be on this engine?<br /><br />Here is what I got:<br />All cylnders were between 85 and 87 psi.
  6. W

    Evinrude/Johnson Owners Manual

    After buying what the seller said was a 1992 Evinrude I have recently found from this forum that it is actually a 1989 Evinrude. Before finding out I of course bought a Seloc Tune Up and Repair Manual for 1992-1996 Evinrudes V4, V6, and V8's. If anyone has a use for this manual and can help me...
  7. W

    Year of Rude??

    Here is the model number off of my 200XP Evinrude. Can someone tell me the year of this engine?<br /><br />Thanks<br /><br />E200STLCE
  8. W

    Sea Foam- Decarb??

    I have read several post relating to the use of Deep Creep Sea Foam to decarb an engine. What is the process of doing so? Start the engine and pull plugs one at a time and spray into the cylinder while the engine is running? I have heard not to run the engine with the airbox cover off. BTW...
  9. W

    Sea Foam- Decarb??

    I have read several post relating to the use of Deep Creep Sea Foam to decarb an engine. What is the process of doing so? Start the engine and pull plugs one at a time and spray into the cylinder while the engine is running? I have heard not to run the engine with the airbox cover off. BTW...
  10. W

    Evinrude starting problem -200XP

    My 200 Rude has a hard time starting for the first time each day. I prime bulb is full of gas before I try to start it. After it has run once, it will be fine for the rest of the day. It seems like it is not getting choked by pushing in the key. I tested the voltage coming out of the switch...
  11. W

    Engine Year??

    How can I find out what year my Evinrude engine is? :confused:
Top