Search results

  1. F

    cant remove the flywheel nut, help!

    tried ratchets, air hammer, a few other methods, wont even budge... soaked in wd40, heated... have the harmonic puller waiting but i cant even loosen the bolt and am considering cutting it off, any suggestions? thanks
  2. F

    running problems on 1989 gt 150

    hi all, I have a 1989 johnson gt 150, starts relatively easily but refuses to stay running more than a few minutes on muffs and while in the water nothing but coughing. i just replaced the spark plugs and seemed to make it run better. i have cleaned the carbs and replaced jets, new fuel line...
  3. F

    float bowl replacements - questions

    where can i get aluminum float bowls for a 1989 johnson gt 150? have had no luck so far. replacing the plastic ones because the are warped and one has a stuck jet - thanks
  4. F

    how to adjust fly wheel, proper positin and purpose - 89Johnson

    what is the purpose the numers and written " cylander 1, cylander 2" on the fly wheel? was told by a mechanic to adjust this as it was the problem for running "shitty " Thanks
  5. F

    1989 Johnson gt 150 - running poorly, sounds bad, bogs at high throttle

    hi all, just completed a carb rebuilt to fix a fuel leak and neeed to leave the primer solenoid on manual, all fixed. turned the motor over and even got my idle down to 600, ish rpms. The problem now, that i did not have previous to the rebuild, is an all around poor sound run. the idle has...
  6. F

    1989 johnson GT 150 - idle problems and choke questions - THANKS!

    Hi All, Ive been rebuilding a 89 johnson for some time now. the motor initially did not run, i replace the power pack, new plugs, and stripped the motor to the crank shaft to clean, etc. after reassembling the motor turned over and sounds great. fine tuning needed but i am running into two...
  7. F

    1988 johnson 150gt - was running, click, no starter, nothing at all

    hi all, i had the engine running, shut off, go to restart and nothing, heard a click. i tested several components and came to replace the engine starter solenoid, but still nothing. any where / thing to look at? - thanks
  8. F

    1988 Johnson 150 - Engine wont star, need some advice!

    So i cleaned the carbs and basically anything i could get into.... replaced the power pack, clean 50/1 gas and a good battery.....i turn the key or jump over the solenoid on the engine, both turn the started at good speed but nothing seems to happen - where should i go from here? anything to...
  9. F

    johnson 2 stroke v6 150 wont start

    hi, so i installed a new start and the fly wheel is now turning, which it was not before, but still the engine doesnt start. what should i be looking for? change out any parts? thanks for any feed back
  10. F

    1988 johnson 150 hp wont start, new starter

    hi all, recently i have begun a rebuild on my grandfathers 1988 bass tracker and johnson outboard. the engine would not start, so i cleaned the carbs and any part of the engine i could get into. put all back together and replaced the old starter, but problem remains i hook up new gas, 50 -1...
Top