The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I have been reading around the web and i have seen several spec sheets for what motor oil to use with my Merc 140. None have dates on them. I will have the boat in 50 degree to 95 degree weather. should i still use a 30w or 40w?
I have a merc 140 with a pre alpha outdrive. i bought it last summer and it ran fine all summer. in the fall when it was in the mid 30s to 40 degrees out side we took it out of the water that was i the mid 30s for the year. it ran real sluggish. could that be from the cold? i put in a new coil...
i have a 1979 sport-craft with a nightmare 470 in it. i have a friend with a boat that has bad stringers and a 5 foot gash down the middle of it. it has a mercruiser 165 in it. the out drives are the same inside and out. will i be able to pull the 470 and bolt the 165 up to it with out to much...
i have a 21' reinell with a mercruiser 140. outdrive is a alpha R drive. i assume they are both 1981 sense the boat is a 1981. i think my RPM gage is wrong, when idle it reads 200 rpm and in and out of gear. at WOT it wont go over 1500 rpm. the boat has good take off and moves at about 28 mph...
i have a pre alpha out drive with a merc 140. i had the muffs on today and noticed water coming from the shifter. where the lower unit and upper unit meet. it looks like its coming from the upper unit. any ideas where it might be from?
i have a merc 140. the shift interrupter switch should kill the engine for a split second. that i do know. i have it sent with a volt meter when i move the v shaped plastic manually. i have had luck in the past doing it that way. my problem is when i use the lever to put it in gear it wont move...
my boat has a merc 140, i have a pre alpha outdrive. i assume its pre alpha sense the top plate on it has a hole as if it was for lifting during the manufacturing process. i was wondering if i would be able to take off the pre alpha and put a alpha I or II on it with out having to do more then...
I have a 1979 merc 470 with a 4bbl Rochester quadrajet carb. just got it used this season. I had to replace the coil,solenoid, plugs, oil, all 3 fuel filters, and gas and reground the starter for other reasons besides the reason im posting a question here. the points looked new so I got a set to...
