Search results

  1. A

    200 Merc Timing Issue

    Have 2001 200 Merc Carb. Having problems wont accerator over 1100 rpm under load. Checking timing went through as per Merc manual setting cranking at 24 BTDC and WOT at 18 BTDC After I ran and adjusted idle speed I assume my timing should be around 9 ATDC . It reads 18 BTDC? Am I assuming...
  2. A

    Reed valves

    Having trouble with my 2001 merc carbureted getting over 1200 rpm under load. Starts , idles , no issues with motor when not under load . Will not get over 1200 under load. Did ever test that I know of in fuel, electrical , etc. rebuilt carbs, new fuel pump,all lines and ball, tank check valve...
  3. A

    2001 200 hp XR6 Carbs will not accelerate under load

    Wont run pass 1100 rpm under load! Compression good, rebuilt fuel pump, new fuel line and ball. Tested spark 7/16 at all plugs. Revs fine in water in neutral. Does not increase speed if I pump ball. In gear on trailer will rev ok . Question is , tried spraying fuel in carbs both in gear under...
  4. A

    200 hp XR6 1 side of cylinders no spark

    Have 200 hp was having trouble with stalling when accerating. Compression good so I thought was fuel problem. Found out one side of cylinders no spark. 2 4 6. Switch box , stater , any suggestions? Would voltage regulator effect anything. Thanks
  5. A

    2001 200 hp xr6 Voltage regulator issue

    Recently purchasd 2001 896 Nitro w/ 200 hp XR6 Took to lake and started right up and idles fine. But in gear under load will not get past 1200 rpms. In neutral rpms get up high no problem. Thought it was fuel issue and still might be. I noticed that one of the red wires ( #18) coming from my...
Top