Search results

  1. R

    Wiring on console messed up

    I have a wiring issue on my console. I don't think it is from my charging system from my motor.when I hook my battery charger unto my battery. It says 12.5V but when i turn on my GPS it says 10v and when I have my radio on and turn on my GPS the radio goes off until the GPS comes on and the the...
  2. R

    150hp EFI Nitro no charging battery

    My 150 hp mercury died on me in the middle of the lake. My GPS would not come on my radio would not come on. I let it sit and it finally started and ran long enough to get me to the launch. I replaced the batterymy GPS came on and the voltage was reading 9.1 when I cranked it. I ran it a few...
  3. R

    Kill switch wiring

    I have a 1994 150hp Mercury. I bought a Saf T Stop ignition kill switch. It is telling me on early models connect black lead to engine ground and red lead to engine mercury tilt switch. On late models connect black lead to black or ground wire in control box. Connect red lead to black/yellow...
  4. R

    Mercury 150 hp EFI Nitro

    I just put in a new water pump and impeller in my motor. First couple of days it was pissing fine. Now it has stopped pissing I took off line and made sure it was clear Any suggestions
  5. R

    Boat hull id

    Can I find out what size fuel tank is in the bottom of my boat by the hull no. If I can what Wellcraft site can I go to. It is a 1981 18 fisherman. I do have an access panel and the tank looks like it is about 4 Ana a half feet long and about 2 foot wide. I can't tell how deep it is I am in the...
  6. R

    Removing Gas tank in the bottom of a Wellcraft

    I am removing the gas tank in the bottom of my wellcraft. They bypassed the tank in the bottom of the boat and put a tank under the console. I want to replace the tank in the floor of my boat. My question is when I removed the access plate I can see all the hose connections and the the tank. But...
  7. R

    Oil buzzer

    I will try and keep this short. I bought a used boat. It has a 150hp Nitro EFI engine. It would not start. I fixed that problem the tank and hose were bad. I cranked the motor and it ran fine. i got it up to 5000 rpm's and the tell tell was flowing strong. My problem is i cracked the cap on my...
Top