The iboats forum moderators are excited to announce that at this time it appears the iboats forums posting pictures function is working once again. Though we cannot promise for how long, we're hoping for indefinitely.
I have a 150hp yammie pro vee, that has had an intermittent overheat buzzer go off for the last 4 mos. it would happen when i was idling around for an extended time like 5-10 min at 5-6 hundred rpm the first time it happened I took it in and had the w/p replaced all was good until a couple of...
I have a 91 150 proV that had the overheat alarm go off while idling around at very low rpm 500 rpm for 5 min or so , I replaced the waterpump and took the boat out a few times and all seemed well but last week the alarm went off again while doing the same thing idling for awhile So I changed...
I have a 1991 pro V , that has a fuel filter under the cowl it is clear plastic which looks kinda dark amber now . I wonder if it is time to change this .
It looks like it should screw apart, is there an element inside I have tried to twist it open with no luck, or is this a one piece unit...
I have a 1991 150hp yammie pro V that has started to make a high pitched moan when I trim or tilt down but is fine when going up , any ideas on this and I was wondering how i check the fluid level on this model ?
thnx
mark
I was looking at a 1991 150hp pro v to buy and i noticed that it had a little movement side to side probably less than an eigth of and inch but most other props i have grabbed had no movement i rode in the boat and it runs fine and doesn't seem to vibrate at idle is this something to be...
I was looking at a 1991 150hp pro v to buy and i noticed that it had a little movement side to side probably less than an eigth of and inch but most other props i have grabbed had no movement i rode in the boat and it runs fine and doesn't seem to vibrate at idle is this something to be...
I was looking at a 17 ft. charger the pacesetter series which used to be an entry glass boat rather narrow beam anyway it has a 1998 90 hp rude which prop should this use I have looked all over the prop that he has on and can't find a single number , it is a stainless one i think. It seems like...
I was lookin at a 96 charger to buy and i know the seller mentioned that he had launched a time or 2 without the plug and i was wondering how much water it takes to waterlog the floatation and is the material usually foam?
thnx
mark
I have a 1989 50 hp force that has the most curl I have ever seen on a prop, it is more curled than most buzz baits i have seen. Does anybody else have one like this and why so much curl?
mark
I have an 89 50 hp that i have had for about 2 yrs motor looks and for the most part run like new . I did a leak down on it when i first got it and it was about 2% even when it was cold! now thats perty good. Anyway i took her to the lake over the weekend and was runnin her around as this is...