Search results

  1. V

    5.0 bravo 3 fresh water flush

    Yea I agree there's just no where for to put it. Is that valve 1 1/4?
  2. V

    5.0 bravo 3 fresh water flush

    1 1/4 hose out of transom to intake (suction) side of pump. Then 1 inch out of discharge(pressure) side out pump. The 1 inch goes into a metal tube where the pressure sensor is, which then leads to oil cooler and then feeds motor.
  3. V

    5.0 bravo 3 fresh water flush

    If I putting another tee in on the discharge side, I was putting the tee right before the cooler
  4. V

    5.0 bravo 3 fresh water flush

    I just installed new heads, manifolds and risers in my 5.0 MPI with bravo 3. Cylinder head had a cracked in the exhaust seat, hydro lock motor. All back together now. I wanted to install a fresh water flush. I installed a tee on the intake side of the pump. The plan was to put a ball valve in so...
  5. V

    Bravo 3 passed pressure test but fails vaccum

    I installed the one piece double seals. Drive was installed and boat back is in water. Had a good trail run with no issues. Thanks again to Alldodge for that write up.
  6. V

    Bravo 3 passed pressure test but fails vaccum

    Yea it's working. So i pulled vacuum, and crimp the line right at the fitting. The gauge held pressure, I took of the crimp on the line and the gauge went to 0.
  7. V

    Bravo 3 passed pressure test but fails vaccum

    Hi All, I have a bravo 3 that failed a pressure test and it was leaking from the inner prop shaft seal (the seal between the big and small shaft). A huge thanks to Alldodge for his write up especially the hose clamp trick it works perfectly. Boat is in salt water and it kicked my butt getting...
Top