Search results

  1. M

    High Engine RPM to Prime Raw Water Pump

    I have had an issue since I purchased my boat where it take a good amount of engine RPM (2500) to Prime Raw water pump. When I first get the boat in the water I let it idle up to temp around 160 - 180 degrees. At this time I need to run the RPM's up to get raw water circulating around my Heat...
  2. M

    Dps-m

    Re: Dps-m Thank Gawd! I read that whole thread (thank you) and was able to put some heat on the bolts but they had been greased before. It was the bearing housing that was really corroded and causing the headache. I used a coupe pry-bars and kept working my way around the mating surfaces and...
  3. M

    Dps-m

    Re: Dps-m I located the Tag on the Port side. Had to sand off a bunch of black paint and it is indeed a DP-SM. Now the question is did I purchase the correct re-seal kit (pictured in my post above) which contains he new Bellows? Also, following the DP-S section in the service manual Don...
  4. M

    Dps-m

    Re: Dps-m Hi dypcdiver (clever handle BTW) Thank you for your reply. have no serial numbers on the drive, I was informed I had a "DPS" not a DP-S(x). This makes things a little difficult as you can imagine. I have a couple questions for you. 1. Do you have two O-rings on your drain plug? 2...
  5. M

    Dps-m

    Hello, This is my first post, so be nice. :cool: I have been researching this site and there is a lot of great information on here. I have been trying to find a list of part numbers for seals to replace. I recently pulled the props on my DPS - M and drained the gear oil. This is the first...
Top