New prop from I Boats Michigan Wheel Apollo part number 993144 and hub kit 108. Prop hits the trim tab on my stock 2003 Yamaha F90 4 stroke outboard. Any ideas what to do? order number 00853000 dated 07/19/06 . everything was ordered correctly and shipped according to order but it just will not...
Any scoop on this hull, Looks well made. Anyone have anything to say about the all welded triton magnum series hulls. I ran across a 2004 176 Magnum , triton trailer, 2005 Merc 115 2 stroke carb engine. Looking to buy
Is 2005 truly the last year for production of carb 2 strokes like my 90 Merc ELPTO or my 15 Evinrude, or my 25 Johnson Tiller. All are on boats where weight could be a real factor?
I am in the middle of adding a 5" extension kit to a late model Johnson 25hp 2 stroke. Going from 15" to 20". I see I will have to pull the powerhead to install the longer shift shaft. I want to make a 5" extension up out of another shift shaft and a coupler. The shaft is the same diameter as...
I have a new 2004 Johnson 25hp short shaft motor. I have oem 5" extension made by OMC in 1986. Comes with engine/exhaust tube rubber mounts and a gasket for between the powerhead and exhaust tube. Is it necessary to pull the powerhead and install these mounts or not and go with the other parts...
I have a in the box omc 5" extension kit for their 25hp two stroke motors 1985 to present. I have done a conversion on a 9.9 from 15" to 20" shaft 1987 model. Did not require that I go into the lower unit. Drive shaft fit in from the top of the lower unit and the shift shaft screwed in - in...
I started my annual end of season checks on my three outboards, 90 merc, 25 merc , 9.9 evinrude. I found milky lube in the lower of the 25 Mercury. This motor I purchased from a Merc dealer new on 01/06/2004. Still in factory warrenty. I have run approximately 24 gallons of pre mixed fuel thru...
I have aquired a good running older evinrude motor complete with controls and cables ect. model# is 33552B with a serial number of E03489. I was wondering what year and model and hp this motor is. thanks in advance
I was just wondering , I have been replacing my Merc 2 stroke 90 every 2 years. I live close to a dealer who sells at a minimum compaired to what I see averaged nation wide. Therefore I can sell and buy new every couple of years without a huge loss. Will the same design 2 stroke Merc 90hp carb...
