Search results

  1. J

    REGULATOR or PUMP??????

    Im chasing my tail but doing best I can. 96 omc 5.8L ford 58fcpnca-model Ran fuel pressure test due to some 100-200 rpm surging. new plugs,wires etc etc etc on the injector rail at idle(500 but should be 600) its 31psi surging to 30 then 31. At 1000 rpm exact same pressure with engine surging...
  2. J

    Self code testing

    I went to do some testing with my home made test kit and my test plug is not the same. Unsure which wires to probe lite and clip to? 96 omc 5.8L 58fcpnca-MODEL#
  3. J

    Omc 5.8 under temp?

    Re: Omc 5.8 under temp? I went to do some testing with my home made test kit:facepalm: and my test plug is not the same. Unsure which wires to probe lites and clip to? 96 omc 5.8L 58fcpnca MOVED TO NEW THREAD!!!
  4. J

    Leaking Bellows?? Where and how!!??

    Re: Leaking Bellows?? Where and how!!?? There are 2 black ribbed rubber hoses coming out of your transom. Back of your boat. Lower one is the exhaust and upper is where your drive shaft goes to the gimbal bearing. Sounds like you are leaking thru the drive bellows and really need to get it...
  5. J

    Exhaust Manifold Noise.

    Re: Exhaust Manifold Noise. here ya go bruce
  6. J

    Omc 5.8 under temp?

    I Have a omc 5.8 EFI 351 that runs at 120 degrees at idle and on the water. The rps at idle are 500 and should be 600 according to tag on motor. My question is, if the motor is running to cool will the engine not reach optimum operating temp and the ecm send mixed signals? At idle the engine...
  7. J

    OMC/Volvo penta cobra sx stern drive

    I need to order a bellows kit. my stern drive tag has a prod # 3868387 ratio 1.51 serial #T0799643 where the "type" is there is no stamp for the type so I just want to make sure I purchase the correct set. Also the shift cable to the stern drive needs to be replaced as the plastic coating is...
  8. J

    Schematic for grounding wires on sterndrive

    I am getting a mess load of corrosion on my stern drive. Yes I have anodes but will replace with new ones next week but my question is, where can I find a schematic for the little grounding wires that connect all over the place on my stern drive? I am doing a bellows change etc so while I have...
Top