Search results

  1. R

    1978 OMC stringer 305 V8 triple solenoid wiring diagram

    PLEASE can someone help me to figure out how these three (3 connectors on each) trim/tilt solenoids` wires go back together? I made the mistake of having a friend (and I use that term loosely now) help me disassemble what I thought was a bad solenoid (turned out the motor is bad but didn`t...
  2. R

    BucksBags SouthFork Pontoon. Swivel seat or no?

    Just scored a couple of used Craigslist BucksBags single man pontoon boats a couple days ago and just happen to have a couple spare boat seats laying around from my boat rebuild. They happen to be the same seats as on the pontoons and are brand new. I had also put swivels under them. I was...
  3. R

    1979 1/2 Merc Mariner 115 T of P won`t fire. Lanyard help?

    Hi guys. I am again at my Tower of Power trying to get a new key switch set up to fire the motor but not having much luck. I have two yellow striped wires AND a solid black wire coming off the rear of my lanyard switch near my throttle lever but I can`t figure out where they go on the key...
  4. R

    1979 1/2 Merc Mariner 115 T of P water in lower unit.

    Hi all. I have this 79 1/2 115 Mariner T of P I bought last year attached to a 77 Sylvan I am just about done restoring. I decided to finally take a look at the gear oil and change it out yesterday and about a quarter cup of water came out with the oil. I checked the prop shaft with pressure and...
  5. R

    1077 Starcraft windshield seal for a rest? Where can I get one or any alternatives?

    I`m restoring a 1977 Starcraft 18ft. aluminum boat and found the new "T" Bolts on EBAY thanks to this forum, but I also need to figure out what I`m gonna do for a new gasket for the whole windshield. My windshield is a "Taylor Made" 5 piece with the number 514862 next to the name "Taylor Made"...
  6. R

    Mercury Shifter on a 77 18` Starcraft. How do I get it to split?

    I have this shifter connected to factory wood that I want to replace with aluminum for the inside drivers side panel. I can`t seem to figure out how to get it apart. I took the "SETSCREW" out and then all the bolts around it to separate the two pieces but to no avail. It all seems loose but...
Top